Vip-Vision INTKIT-A1 Quick Start Manual

2 1. Introduction 2. Included Components Thank you for purchasing this Intercom System. This install guide covers basic setup and installation for your intercom system. For detailed technical support and software downloads, visit our Help Centre at: help.c5k.info help.c5k.info IMPORTANT: • Door Stations are designed to mounted in a sheltered location, not exposed directly to weather. • When installing the Door Station, apply outdoor silicone sealant between the Door Station and the wall, and seal the hole that has been created for the cable to prevent water ingress. If using a mounting box, ensure the box is also sealed, and the included waterproof rubber seals are used when installing the screws.

4 4. Front Panel Button Description • Press to hang up the incoming call without answering. • Press to adjust monitor settings. • In set up mode, press to decrease value. • Press to answer incoming calls. Press again to hang up. • In set up mode, press to increase value. • Press to cycle between video live views of Door Station 1, Door Station 2, Camera 1 and Camera 2. • In set up mode, press to skip to next item. • Press to unlock the door where the door station(VTO) calls. • In set up mode, press to exit set up menu. Button Description Call • Press once to call door monitor(s) Indoor Monitor Door Station

5. Back Panel Name Description Power PWR 12VDC positive input G 12VDC negative input Camera Ports CAM Analogue camera signal input G Analogue camera signal ground Door Station Ports P1, P3 12VDC positive output to door station V1, V3 Video signal A1, A3 Audio signal G Common ground for door stations Indoor Monitor Ports P2, P4 12VDC positive input to monitors V2, V4 Video signal A2, A4 Audio signal G Common ground for monitors

6 6. Wiring 7. Wiring Example - One Door Station and One Indoor Monitor Port connection rules • Port A of the indoor monitor can be connected to Port C of another indoor monitor. • Port B of the indoor monitor can be connected to Port D of another indoor monitor. • Port A of the indoor monitor cannot be connected to Port B or D of another indoor monitor. • Port C of the indoor monitor cannot be connected to Port B or D of another indoor monitor.

8. Wiring Example - Three Door Stations and One Indoor Monitor

8 9. Two Door Stations and Three Indoor Monitors

10. Setup Menu Button Description • Open the menu • Wake up the monitor • Decrease Vol (volume), Bright (brightness), Contrast and BellVol (bell volume), change Bell tone and turn off DND (do not disturb) • Increase Vol (volume), Bright (brightness), Contrast and BellVol (bell volume), change Bell tone and turn off DND (do not disturb) • Select an item to adjust or change • Exit the menu and lock the screen

graphics presented in this guide are the property of their respective owners. See www.c5k.info for more information. For detailed technical support and software downloads, visit our Help Centre at: help.c5k.info help.c5k.info