SEGUE RE-1050 Setup Instructions
Text of the manual
RE-1050 10’x10’ Hybrid Display
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection
Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup
SEG Graphic Installation
Graphic Removal
To remove the graphic
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this co
CEI110 Frame Assembly
CEI-110 Profile
Straight Bracket Assembly
1) Slide TWO-PIECE TS RV 4 straight bracket into
Interior Center Slot of extrusion, so that two of the
set screws are inside groove. Tighten two set screws
to secure.
3) Slide connecting extrusion over exposed ends of
bracket & connector. Tighten all remaining set screws
to secure extrus
Step 1 of 1
2
4
5
2A
5A
4A
3A
3
Item
1
2/2A
3/3A
4/4A
5/5A
Qty.
4
1/1
1/1
1/1
1/1
Description
Base Plate
56” CEI110 Horizontal Extrusion
56” CEI110 Horizontal Extrusion
95” CEI110 Vertical Extrusion
95” CEI110 Vertical Extrusion
Steps:
1) Assemble extrusions [2] thru [5A] as shown.
See CEI110 Frame Assembly sheet for details.
2) Attach base p
