SEFRAM SEQUENCER SET18DP Manual 

WARRANTY: The Warranty does not apply in the following cases: - Breakage through dropping or knocks to non-packaged products - Damage caused by abnormal use of the device, connecting error, surges/overvoltages, overpressure, etc. - Any intervention on the device apart from the connections In case of failure, no action is permitted and the unit must be returned to the following address: CERTIFICATE: The SET18DP respects the European directives ( CEM, BT), which concerns it. However, it must be used ...

General instructions for safety, assembly, commissioning, usage and maintenance to be read before working on the device I. GENERAL These instructions must be read jointly with: +the standard NFC15-100 +the technical data sheet specific to the device The Sefram devices are designed to be assembled, commissioned and used in compliance with the characteristics/data given in the technical data sheet. Always adhere to all of directives, legislation, orders and most recent standards in force for the sta ...

General instructions for safety, assembly, commissioning, usage and maintenance to be read before working on the device I. GENERAL These instructions must be read jointly with: +the standard NFC15-100 +the technical data sheet specific to the device The Sefram devices are designed to be assembled, commissioned and used in compliance with the characteristics/data given in the technical data sheet. Always adhere to all of directives, legislation, orders and most recent standards in force for the sta ...

Page system informations: 1 : Indicates the serial number of the device 2 : Indicates the software version of the central unit card. 3 : Indicates the software version of the user interface card. 4 : Indicates the name of the device. 5 : Indicates the current protection level. 6 : If press this area : go back to page menu. 7 : If press this area : go back to main page. RUNNING : Conditions to start declogging cycle : - Input I1=1 (input closed) - Running order dP ON (if cycle is dependent on load ...

PROTECTION : Protection fuse of SV outputs is reachable after dismounting the connections cover. (see table 1 for the calibre of the fuse). VOLTAGE CHOICE : It is possible according to the version of the sequencer to set differently the supply voltage and the solenoid valves voltage of that made by default in factory answering the ordered version. warning: the device must be switched off. Remarks: - The supply choices "115V / 230V" or "24 / 48V" can be made only with order - If supply voltage "115V ...

Page measure load loss dP : 1 : Graph of the measure of load loss dP. Display of the 7.5 last hours of running of the device (1pt every 90 seconds). When device is turned off, the graph is reset. The different running thresholds and alarm thresholds are displayed by horizontal lines with colour corresponding to the legend, on the left part of the screen. Remark : if one running threshold or one alarm threshold is adjusted to 0, this one will not be displayed. 2 : If press this area ...

If version till 10 SV with individual cable (1 common + ground for each SV) : Supply Depending on the version 115V/230V 24V/48V 50/60Hz Connection of outputs Solenoid valves 1 to 10 Output 4-20mA for register, indicator, etc. Maximal charge : 500 ohms Output information default/alarm Input I1 10x common EV 10x ground SV 1 to 10 ...