Sealey ECS650 Instructions Manual

12/24V 650AMP MAX MODEL NO: ECS650 IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WAR ...

 Familiarise yourself with the applications, limitations and potential hazards relating to the starter/charger. Also refer to the vehicle manufacturer’s handbook. IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.  Ensure the starter/charger is in good order and condition before use. If in any doubt, do not use the un ...

Original Language Version © Jack Sealey Limited fig.2 fig.1 Data Plate ...

5.1. Signalling LEDs. There are 15 LEDs on the front panel having the following functions: • 4 battery status LEDs, indicating: Full: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . battery is charged and is in Charge Maintenance status. Charging: . . . . . . . . . . . . . . . . . . . . . . ...

To start a vehicle with a flat battery, this mode consists of the following steps (this model also has a control switch on a cable for supplying extra power in this mode): • STEP 1: Battery analysis: The charger’s Start LED flashes. • STEP 2: Fast Charging: The charger enters this step if the Start LED is steadily on. It sets the ch ...

Position the clamps correctly and start charging the battery again; (see section: 7.2. Operating the Charger). Battery completely short-circuited. The battery could be defective. Contact your nearest battery service centre. Err02 Battery faulty ...

sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable) into a ...