Scag Power Equipment SWZ36A-14FS Operator's Manual

Any part of the Scag commercial mower manufactured by Scag Power Equipment and found, in the reasonable judgment of Scag, to be defective in materials or workmanship, will be repaired or replaced by an Authorized Scag Service Dealer without charge for parts and labor during the periods specified below. This warranty is limited to the original purchaser provided the product was purchased from an Authorized Scag Power Equipment Dealer and is not transferable. Proof of purchase will be required by the dealer to substantiate any warranty claims. All warranty ...

Construction................. 36 / 48 = 7-Gauge Deck Top w/10-Gauge Reinforced Spindle Area, 7-gauge (3/16") Deck Skirt 52 / 61 = 10-Gauge Deck Top w/10-Gauge Reinforced Spindle Area, 7-Gauge (3/16") Deck Skirt True Cutting Width: 36..........................................................................................................................................................35.5" (90.2 cm) 48. ...

2 462773 Oil Reservoir (With Fittings) 3 482572 Fitting, 90 Degree - 3/8" Hose 4 48811 Hose, 3/8" ID - 10-1/4" Long (Order By The Inch) 5 48811 Hose, 3/8" ID - 7" Long (Order By The Inch) 6 48603-06 O-Ring 7 483097 Pump, PG-1JQQ-DY1X-XXXX (R.H.) 8 483098 Pump, PG-1GQQ-DY1X-XXXX (L.H.) 9 04003-11 Bolt, Carriage, 3/8-16 x 1.25" 10 481265 Hose, Pump to Wheel Motor 11 482571 Bushing, .56 Dia. Viton 12 482266-03 Elbow, 7/16-20 O-Ring x 3/8" Hose 13 48811 Hose, 3/8" ID - 11" Long (Order By The Inch) 14 482417 Oil Filter Base 15 ...

4.11 STOPPED To “free-wheel” or move the mower around without the engine running, turn the dump valve levers located on the back of the pumps counter clockwise to the "freewheel" position and move the mower by hand. To operate the mower, the dump valves must be turned clockwise to the closed position. Dump Valve Levers Dump Valves Figure 4-3. RECOMMENDATIONS FOR MOWING 4.12 Do not mow with dull blades. A dull blade will tear 1. grass, resulting in poor lawn appearance and reduced mowing power. WARNING DO NOT operate without Discharge Chute, Mulching ...

Adjusting the blade height can be done by moving any number of the five smaller 1/4" spacers on the blade mounting bolts to the top of the spindle shaft or below the spindle shaft. -NOTE- All blades should be positioned equally. WARNING Blades have a sharp cutting edge. Wear proper eye protection and protective gloves or wrap the blades with protective material when removing, sharpening and installing blades. For best cut and discharge, a minimum of three spacers should be installed between the blade and the spindle. See Figure 6-9. 2002 SC407G Blade Spa ...

Figure 7-2. Re-install the drain plug into the tee fitting and be 3. sure it is tight. - NOTE - Before refilling the hydraulic oil reservoir the hydraulic oil filter should be changed as outlined in Procedure C "Changing Hydraulic Oil Filter Element". Fill the reservoir to 2" inches from the top of the filler 4. neck with 20W50 motor oil. Replace the reservoir fill cap. Start the engine and 5. drive forward and backward for two minutes. Check the oil level in the reserv ...