panthera Bambino 3 Assembly Instructions

ASSEMBLY INSTRUCTIONS art.nr. 8822126 Rev.2021-01 TRAY-TABLE AND MAGNETIC HOLD BAMBINO 3 Assemblu instructions: Tray table and magnetic hold Bambino 3 art.nr. 6810000 Tray table art.nr. 6810008 Magnetic hold Max. load 5kg Tools aquired: Allen key 3 mm, Pliers Cutter / scissors Tray table Magnetic hold on rear wheel 6) Place the table brackets in the holes in the side guards as shown in the picture and push down to the bottom. 1) Width 24 cm. Use the inner holes for moun- ting. 2) Width 27 cm. Use the outer holes for moun- ting. 3) Width 30 cm. Use the inner holes for moun- ting. Note that the brackets have changed places between left and right compared to fig 1 and 2. 4) Width 33 cm. Use the outer holes for moun- ting. Note that the brackets have changed places between left and right compared to fig 1 and 2. Placement of the brackets under the tray table for different seating widths of the wheelchair. Letters ”A” and ”B” are stamped in the brackets. Table seen from below. 5) Turn the table over and screw in the screws. Make sure that the screws are tightened into the slot.

7) Place the magnetic hold centered on the outside of the wheel. Rotate for each pair of holes are located over two spokes. If the wheels have spoke guards, first you need to drill 6 holes through the spoke guards (5 mm). Center the magnetic hold on the spoke guard and use as a template. 8) Thread the cable ties from behind to get the eyelet to end up on the back of the bracket. Tighten the tie holds hard. Cut the ends of the cable ties. If the wheel has spoke guards, the cable ties are pulled through both spoke guards and the magnetic bracket. 9) Attach the tray table to the wheel by aligning the magnets in the table and the hold on the wheel. Mounting of magnetic hold