TJERNLUND 9900000 Instructions

1601 Ninth Street • White Bear Lake, MN 55110-6794 PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547 Visit our web site • www.tjernlund.com Large Burning Box (9900000) WARNINGS: • Do not handle these parts without hand protection! All parts of this product are made of Stainless Steel which can have sharp edges!!! Gloves have been provided for the user to wear during the assembly, handling and use of this product. • Never leave this product unattended! This product must be supervised when in use and stored out of reach of children and unprotected adults when not in use. • Never use this product within 15 feet of combustible materials. This device gets extremely hot when in use and can start adjacent combustible mate- rials on fire. • Always insure the burning materials in this device are 100% extinguished before no longer supervising it. • Never touch this product when in use. It does burn extremely hot and will very quickly burn anything that touches it including human flesh. • Never have children within 20 feet of this product. Cuts or burns can result if the product is touched or handled without hand protection. CAUTION: The parts of this product can have sharp edges and can cause cuts if not handled properly. Wear a set of gloves ANYTIME this product is handled. Put provided gloves on to assemble this product. Make sure all parts are accounted for. Place parts in an orderly manor on a surface where they can be easily identified. READ INSTRUCTIONS CAREFULLY PRIOR TO ASSEMBLY & OPERATION Caution: Do Not use accelerants in the burn barrel. Accelerants produce high concentrations of heat that can cause damage to the Burn Barrel! Warped Burn Barrel parts are not covered by the war- ranty of this product.

bit and a 11/32” nut driver or wrench to hold nut on inside, install (5) of the 3/8” X 8-32 stainless bolts and nuts down each corner. Locate the (4) feet and form the tabs on the feet as shown. The tabs should be formed up and should be about 90 degrees from the base foot. Locate the bottom of the Burning Box by identifying the mounting holes for the feet. Position the Burning Box with the bottom side of the Box facing up as shown. Position the feet and mount them in place. Locate the (4) Burning Material Support Brackets and form the tabs using a pliers as shown. Install the first (2) support brackets into the Box as shown using the holes furthest away from the feet. The (2) brackets are to be mounted side by side from each other and run parallel across the box.

closest to the feet. Locate the (3) handles. The rolled over material on each handle is to be located on the inside of the handle. Manually form the (3) handles into shape using a pliers. Mount (2) of the handles to the sides of the Burning Box. The handles are to be positioned and mounted on opposite side of the Burning Box. Mount the last handle to the outside surface of the Burning Box Cover. ©2016 TJERNLUND PRODUCTS, INC. ALL RIGHTS RESERVED P/N: 8504226 REV A 1016