Loop Telecom Loop-IP6702A TDMoEthernet Operation & User’s Manual

Loop Telecommunication International, Inc. 30 Boots : 2 Total User: 2 [User 01] . . . Engine ID : 0000263F00000050C60FA8B9 User Name : loopmd5 Auth Protocol: MD5 Auth Key : 22970DFDBDC8F39EBB323FFB4886B126 Priv Protocol: DES Priv Key : 22970DFDBDC8F39EBB323FFB4886B126 Status : Active Storage : NonVolatile << ESC=>return to previous menu, LEFT/RIGHT=>prev/next user, F=>find user >> << E=>edit engine, ENTER=>edit user, C=>clone user, A=>add user, D=>delet ...

Loop Telecommunication International, Inc. 17 Red Detected any E1/T1 or WAN/LAN or DTE port alarms ETH1 LINK/ ACT Off Link Down Green Link Up A valid network connection on the Ethernet port. 100 Green 100Mbps ETH2-ET H4 LINK/ ACT Off Link Down Green Link Up A valid network connection on the Ethernet port. Flashing Green Active. Data is being transmitted or received through the Ethernet port. 10/100 Off 10Mbps(only for electrical Ethernet) Green 100Mbps E1/T1 ACT Off Signal unsync Green Line Sync TEST Off ...

Loop Telecommunication International, Inc. 74 E1 Port A == Port Configuration == 15:03:56 01/18/201 6 FRAME = ON CODE = HDB3 INTF = 120 OHM AIS = ON RAI = OFF IDLE CODE = D5 OOS = BUSY << ESC key to return to previous menu, SPACE bar to refresh >> 5.16.1.11. Port Status The full menu path for Bert Test is as follows: O > Logon P > Choose a Port I > Port Status The screen of Port Status will show as below. E1 Port ...

Loop Telecommunication International, Inc. 34 ETH2 No Fwd 0____ 000 No shared ETH3 No Dis 00000 000 No shared ETH4 No Dis 00000 000 No shared << Press ESC key to return to previous menu or save the setup>> Table 5-6 ETH Setup (with STP selected) Field Setting Options Default Setting Cost 0 ~ 65535 00000 Prio 0 ~ 240 000 The ETH screen when RSTP is selected: IP6702A === RSTP Setup === 15:27:21 01/18/2016 ARROW KEYS: CURSOR MOVE, Please In ...

Loop Telecommunication International, Inc. 76 T1 Port A === Port Setup = == 12:52:55 01/18/2016 ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS FRAME = D4 CODE = B8ZS INTF = SHORT HAUL EQU = 0-133 YEL = OFF AIS = OFF CAS = ON IDLE CODE = D5 OOS = BUSY << Press ESC key to return to previous menu or save the setup>> Table 5-25 Port Setup Field Setting Options Default Setting FRAME D4, ESF, ESF&T ...

iii 5.16.1.12. Port Alarm History ............................................................ 74 5.16.2. T1 Sun-Menu ............................................................................... 75 5.16.2.1. Port Setup .......................................................................... 75 5.16.2.2. Port Loopback Test ............................................................ 76 5.16.2.3. Clear Performance Data .................................................... 77 5.16.2.4. Port Alarm Setup ............................................... ...

Loop Telecommunication International, Inc. 4 1.4. Specifications Specifications SFP Optical Module Please refer to SFP optical module brochure for detail. Ethernet Optical Interface Number of Ports: Optical port Optical Port Speed : 100 BaseFX (802.3u) Connector: SFP Ethernet Electrical Interface Number of Ports: 3 Speed: 10/100 BaseT (802.3i, 802.3u) Auto-negotiation (10/100) Auto MDI/MDIX Full/Half Duplex Connector: RJ45 E1 Tributary Interface Number of Ports: 1 Input Signal: ITU G.703 Line Rate: 2.048 ...

Loop Telecommunication International, Inc. 54 5.10.1. Config Display The full menu path for Config Display is as follows: O > Logon C > System Display A > Config Display The screen of Config Display will show as below. IP6702A === Config Display === 12:38:34 01/18/2016 IP Addr. : 192.168.220.046 Subnet Mask : 255.255.255.000 Remote loss : continue Active bundle Timer (s) : 90 [CONSOLE port] Baud Rate : 9600 Data Length : 8-Bits Stop Bit : 1-Bit Parity : NONE << ESC ...