modway EEI-3052 Quick Start Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 5 Thank you for purchasing the MODWAY DINING TABLE！ Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2. Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes. 3. Please do not use any tools other than those provided or recommended in these instructions. 4. Please do not throw away any of the packaging or the instruction until you have checked all the components and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and environmentally friendly way. 5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the components from time to time, so please save the tools that have been provided. 6. Please keep all fitting out of reach of children. Hardware: A. Bolt M10x680mm x 4 B. Flat Washer M10 x 4 C. Nut M10 x8 D. Wrench x1 E. Tube Plug x4 Component: 1 Glass x1 2 Frame x1 3 Leg x4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 5 STEP 1: Insert 4 pieces of Bolts (A) into Nut (C). Tighten Bolts (A) by hand. Hardware & Tools required STEP 2: Put Frame (2) on a carpeted or padded surface. Insert 4 pieces of assembled Bolts (A) into the pre-drilled holes on back of Frame (2). Tighten Bolts (A) clockwise until secure by hand.

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 5 STEP 3: Insert 4 pieces of Legs (3) on Bolts (A) through the pre-drilled holes on Legs (3). STEP 4: Insert 4 pieces of Nuts (C) with 4 pieces of Flat Washers (B) into the pre-drilled holes on Legs (3) to the end of assembled Bolts (A). Use Wrench (D) to tighten Nuts (C) clockwise until secure. Hardware & Tools required

Customer Service 908-368-1025︱www.modwayfurniture.com Page 4 of 5 STEP 5: Insert 4 pieces of Tube Plugs (E) into the end of pre-drilled holes on Legs (3) as shown. Hardware & Tools required STEP 6: Carefully turn over the assembled dining table.

Customer Service 908-368-1025︱www.modwayfurniture.com Page 5 of 5 STEP 7: Then carefully put Glass (1) on Frame (2) as shown. STEP 8: Assembly is complete. Your dining table is ready to be used now!