Mitsubishi Electric MR-J5-G Series Operation & User’s Manual

2.2 Startup 2.2 Startup Outline This chapter describes the setting procedure for CC-Link IE Field Network Basic. Refer to the following for startup of the servo amplifier. MR-J5-G/MR-J5W-G User's Manual (Introduction) MR-J5D-G User's Manual (Introduction) Precautions • To ensure the safety of the system against unauthorized network access, take security measures such as using a firewall. • When the value of [Pr. PN02 Communication error - Detection time] is small, [AL. 086 Network communication error] may occur when the power of the servo ampli ...

2.3 Application function 63 2 2.3 Application function CC-Link IE Field Network Basic Diagnostics The servo amplifier supports the following CC-Link IE Field Network Basic diagnostic functions CC-Link IE Field Network Basic diagnostics is a function that uses an engineering tool to check the status of the master station and each slave station. This function can be used to check detailed information such as master station parameter settings and network connection status. Refer to the GX Works2 or GX Works3 manual for details of each function. IP address settin ...

2.4 APPENDIX 95 2 • Control DI 7 • Control DI 8 Bit Symbol Description Reference 0  The value at reading is undefined. Set "0" when writing.  1   2   3   4   5   6   7   8   9   10   11   12   13   14   15   Bit Symbol Description Reference 0  The value at reading is undefined. Set "0" when writing.  1   2   3   4   5   6   7   8   9   10   11   12   13   14   15   ...

2.4 APPENDIX The following shows the related correspondence between the command bit setting and the PDS state. In order to avoid missing the command at the time of communication error, maintain the state of Bit 7 = 1 on the Fault Reset command for at least 10 ms when the communication cycle is 4 ms or less, or at least 20 ms when the communication cycle is 8 ms. 0: Off 1: On : Neither on/off has an influence on the process In order to transition from the "Switch on disabled" state to the "Operation enabled" state, it is necessary to give each command of ...