Mitsubishi Electric MELSERVO J5 Series Operation & User’s Manual

We will repair any failure or defect hereinafter referred to as "failure" in our FA equipment hereinafter referred to as the "Product" arisen during warranty period at no charge due to causes for which we are responsible through the distributor from which you purchased the Product or our service provider. However, we will charge the actual cost of dispatching our engineer for an on-site repair work on request by customer in Japan or overseas countries. We are not responsible for any on-site readjustment and/or trial run that may be required ...

55 4 4.4 Duplicate setting Servo amplifier parameters for which setting has been completed can be copied to another servo amplifier. Use this function when replacing the servo amplifier of equipment with another servo amplifier during operation, and when starting up multiple devices with the same configuration. Restrictions ■The following data is not duplicated. Set them as required after the duplication. ■The following data is not duplicated. • Alarm history data • Drive recorder data Duplication using MR Configurator2 1. The data set in MR Configur ...

9 1 ■MR-J5W_-_G *1 : The corresponding item is included or supported. : The corresponding item is not included or not supported. *2 Not available on the MR-J5W3-_G. 1.3 Servo amplifier/motor combinations Refer to "Servo amplifier/motor combinations" in the following manual. MR-J5 User's Manual (Hardware) Item Special specifications *1 Detailed explanation Not attached (standard model) -ED CN2L connector   Page 39 External encoder connector Linear servo system Two-wire type   Four-wire type   A/B/Z-phase d ...

51 4 Test operation of the servo motor alone in test operation mode • If the servo motor operates in an unintended manner, stop the servo motor with EM2 (Forced stop 2). Check that the servo amplifier and servo motor operate normally. With the servo motor disconnected from the machine, use the test operation mode and check whether the servo motor operates correctly. This section describes how to check the servo motor operation in the JOG operation. The test operation also includes the positioning operation and program operation. ...