Kusam-meco KM 60-T Operation Manual

terminals, do not connect the test leads to any circuit in parallel or it will damages the fuses and the instrument. 5. After the completion of all the measurement operation, you should first turn off the power & then disconnect the test leads & the measured circuit connection, Especially to high current measurement. 6. It is forbidden to input more than 36V DC, 25V AC Voltage between the current jack & the “COM” jack. 3000 AC mA SELECT HOLD MAX/MIN REL RANGE FUSED FUSED CAT III 600V 10secMAX 10A MAX 600mA 75 ...

is as follows: The figure on the right shows the schematic diagram of DC mA . 1. Insert the black meter pen into the “COM” jack and the red meter pen into the “V/Ω/Hz” jack; the default value of the current is DC, trigger the “SELECT” key to switch between AC & DC current. 2.Turn the range switch to the corresponding DC/AC m A gear, trigger “ SELECT” to select AC m A and then put the meter into the circuit to be measured. The measured current value and the current polarity of the red test point will also be displayed at the same time ...

DIGITAL MULTIMETER This Test Certificate warrantees that the product has been inspected and tested in accordance with the published specifications. The instrument has been calibrated by using equipment which has already been calibrated to standards traceable to national standards. MODEL NO. _____________ KM 60-T SERIAL NO. ___________ DATE: ___________ ISO 9001 REGISTERED QC PASS KUSAM-MECO 23 WARRANTY Each “KUSAM-MECO” product is warranted to be free from defects in material and workmanship under normal use & service. The warranty period ...

to the corresponding DC/ACA position. The default value is AUTO DC6A/10A. Then connect the meter to the circuit under test. The measured current value and the current polarity of the red test point will be displayed on the screen at the same time. trigger “SELECT” key to select AC current AC6A/10A: NOTE : 1.The instrument series connection to the circuit pending to test before the circuit should be the first power off. 2. The maximum input current is 10A (depending on the insertion position of the red meter pens), not more than 10 secon ...

storage temperature (23.5)°C, Relative Humidity <75%. DC Voltage AC Voltage DC Current AC Current Resistance Diode\On-off Frequency Capacitance NCV Zero line /Fire Wire Test Full unit symbol Backlight manual / Auto off True RMS measurement. Performance (Note “ ” Indicates that the instrument has this function ELECTRICAL SPECIFICATIONS : 04 5.000 DC V SELECT HOLD MAX/MIN REL RANGE FUSED FUSED CAT III 600V 10secMAX 10A MAX 600mA 750V DC 1000V DC 10A COM VWHzmA mA out AUTO POWER OFF TRUE RMS OFF V V ~ NCV W Hz % ...

(International Electro-technical Commission promulgated safety standards), before use, please read the safety precautions. 1. When measuring the voltage, please input the limit voltage of DC 1000V or AC 750V rms. 2. The voltage below 36V is safe voltage. When measuring above 36V DC & 25V AC voltage, check whether test pen is reliable contact or right connected or good insulation properly, whether insulation is good & so on, in order to avoid electric shock. 3. When Change function & range, test pen ...