Konig Security SEC-APC10 Instructions
Text of the manual
With Remote Control
Description:
Figure A
Figure B
Alarm
Remote control
1. PIR sensor
8. Arm button
2. Siren
9. LED indicator
3. Infrared sensor
10. Disarm button
4. Battery LED indicator
11. Battery compartment
5. External power connection
12. Program switches
6. Mounting bracket
13. Battery cover
7. Battery compartment
ENGLISH
INSTRUCTIONS
1. The battery compartment is accessed
from the rear of the alarm by removing the
screws of the mounting bracket.
2. Insert 4x C size batteries (not included)
according the correct polarity
(see figure C)
3. When the batteries are inserted the
alarm will beep very loud to indicate that
the batteries are properly installed.
4. Replace the mounting bracket and fix it
with the screws. The battery LED indicator
will light when the batteries are LOW and
need to be replaced.
Remote control:
The remote control uses 3x LR44 batteries (included). If the red
LED indicator on the remote control does not light up when the
‘ARM’ or ‘DISARM’ buttons are pressed, then the batteries need to
be replaced.
Program alarm:
1. Set the switches (12) of the remote control to the desired code
and remove the batteries from the alarm. Then wait at least 30
seconds for the alarm to reset.
2. Aim, immediately after inserting the batteries, the remote control
at the alarm and press the ‘ARM’ button. The Alarm LED will flash
once to indicate that it has learnt the code of the remote control.
NOTE: the alarm must be programmed again with the remote
control each time the batteries are replaced.
1. Locate the desired location for the alarm
on the ceiling in the center of the area that
needs to be secured.
2. Remove the mounting bracket and fix
this to the ceiling with screws. Then fix the
alarm to the mounting bracket and secure
this with the screws at the sides.
Operation:
Aim, when leaving the protected area, the remote control at the
alarm and press the ‘ARM’ button. A confirmation tone will indicate
that the alarm is armed and you have 30 seconds to leave the area.
After this time, if motion is detected, the alarm will sound.
Aim, when entering the protected area, the remote control at the
alarm and press the ‘DISARM’ button. There is a short beep, when
entering the area, to indicate that motion has been detected. You
have 4 seconds delay to disarm the alarm.
Remark: if the LED indicator is constantly on, it means that the
batteries need to be replaced.
Warning:
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician if service is required. Do not
expose the product to water of moisture.
Warranty:
No guarantee or liability can be accepted for any changes and
modifications of the product or damage caused due to incorrect use
of this product.
General:
Designs and specifications are subject to change without notice.
www.konigsecurity.info
