NEC NP-90MS01 Installation Manual
Text of the manual
Setting of IP address of Ether 0 and Ether 1
After saved, reset IMS.
After pushed reset, please wait about 5 minutes for lead time of changing IP address.
Input address
and save
①
②
③
④
⑤
⑥
Device Manager setting
When you use new NP-90MS01, you need to set Device manager.
If you do not set Device manager, you can not use marriage function of the projector with NP-90MS01.
①
②
③
④
Select Projector
Fill same setting without IP address.
DLP IP : 192.168.10.10
Save setting
HDMI and SDI setting
When you use HDMI and SDI, you need to set the device controller every time.
GUI store the previouly setting after set the device controller in future.
1. First setting.
①
②
③
④
Select Manual
Input Projector IP.
Push Connect
Select DEVICE CONTROLLER
2. Second setting.
When you use the function without power off and log off, please use as follows;
If you powered off the IMS, you need to set Device controller for '1. First setting'.
⑤
Select input terminal.
②
IMSを選択
DO NOT use shutdown function of NP-90MS01.
If you powered on the NP-90MS01, please power on the projector.
When the projector is standby mode, the NP-90MS01 is not Power-on mode.
So you can not log-in the GUI of NP-90MS01.
①
②
Do not use Shutdown function.
If you push this, please power off the
projector.
