Lefroy Brooks M2-5341 Installation Instructions Manual

Whilst every effort is made to ensure accuracy, design and dimensions are subject to change without notice as part of the company’s product development process. Ø1 15/16" Ø1 1/16" Ø1/2" Ø1 3/8" 5/8" 1 5/8" 1/8" 5/16" (Ø50mm) (Ø27mm) (Ø12mm) (Ø35mm) (15.9mm) (42mm) (3mm) (8mm)

Hacksaw Phillips Screwdriver Pipe Tape Spatula Spirit Level Your new bathroom faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, wire wool and harsh chemicals as these will dull the finish and void your warranty. If you are soldering during faucet installation, remove cartridges, seats, gaskets and washers prior to applying flame, otherwise you will void the warranty. Cover drain openings to avoid losing small parts. When cutting or soldering pipe, use safety glasses to protect your eyes. Correct installation may vary depending on previous faucet installation. All necessary supplies required for faucet installation are not included, but may be found where plumbing supplies are sold. It is suggested that IAPMO and/or CSA approved plumbing supplies are used during installation. Prior to beginning installation. turn off the cold and hot water lines and open the old faucet to release built-up pressure. Overtightening nuts may cause damage. Wrap all threaded connections with pipe tape available at your local plumbing supply store. Always wrap in a clockwise direction. The fittings should be installed by a state-licenced plumber. Tools: Maintenance Safety Tips Things You May Need Important Points Meets A112.18.1 Standards

Shut off main water supply before installation. 3 Place assembly over the mounting bracket with set screws facing down. Tighten the set screws. 1 Position the mounting bracket on the wall where required. Please note the direction of the bracket should be as shown. Mark the location of mounting screws. Drill holes in the wall to fit the anchors. Tap the plastic anchor into the hole with a hammer. 2 Position the mounting bracket to be mounted on the wall, then thread the fixing screws through the mounting hole into the plastic anchor. Turn the screws slowly until they are tight. 3 2 1

Bracket (245027) Screw (008715) Mounting bracket (293014-3) Anchor bolt and screw (290411) Set screw (292547) Allen key (031003) 1 2 3 4 5 6 7 1 2 3 4 5 6 7

registrations, trademark registrations and copyrights are protected by law and the use or reproduction outside the terms of an agreement is prohibited. The right to modify designs and dimensions is reserved. Christo Lefroy Brooks is a member of ACID (Anti Copying in Design). LEFROY BROOKS INC, 1828 TROUTMAN STREET, RIDGEWOOD, NY, 11385 TELEPHONE: 718-302-5292. FAX: 718-302-4177 ©CHRISTO A. LEFROY BROOKS 2009 %&$$"''$'(&'&)$(("" 718-302-5292 *+!+%&$ www.lefroybrooks.com