GUBI COBRA Assembly Instructions

C A R E I N S T R U C T I O N S T E C H N I C A L I N F O R M A T I O N T R O U B L E S H O O T I N G Unplug power cord prior maintenance. To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners. Light source: E14, recommended bulb 4 W LED 400 lumens. - Max LED 8W max Turn power off when changing light bulb. Isolation class II. The lamp is not approved for outdoor use or use in damp/wet rooms (IP20). If lamp does not light, turn off the power. Check the bulb for a broken filament. Replace bulb if necessary, then turn it on. If the lamp still does not light, please contact customer service at the local dealer. If the external flexible cable or cord of this lamp is damaged, it must be replaced by a qualified electrician in order to avoid a hazard. For enquiries contact GUBI A/S - CVR: 17940384 Klubiensvej 7-9. 2150 Nordhavn. Copenhagen, Denmark T +45 69 15 60 60 – [email protected] GUBI.COM

1. 3. 2. 4. Unpack lamp. Plug lamp to main voltage. Place on stable ground. Push switch to turn lamp on and off. 1 Unpack lamp. 2 Place on stable ground. Do not look directly at lighted bulb. Turn off / unplug and allow lamp to cool before replacing bulb, cleaning or other maintenance. Do not use in the bathroom or damp places. CAUTION: TO REDUCE THE RISK OF FIRE, USE MAX. 40 WATT INCANDESCENT, E12, type b bulb,120V 60Hz AC ONLY. Do not exceed recommended wattage. CAUTION! IMPORTANT: LAMP MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN! PREPARATION: Shut the power off. Step 1 Step 2 3 Plug lamp to mains voltage. 4 Push switch to turn lamp on and off. 4 3 53-15-005-01 Mounting instr. Cobra Table lamp US