Audix M70WD Installation & Operating Manual

solution to eliminate multiple connectors by providing audio, LED status and logic functionality with a single RJ45 cable connection. This design reduces conventional wiring and installation time by 90% and eliminates wiring errors. Once the connection is made to the network via the Audix DN4 interface, the Audix microphone(s) will be automatically recognized and populated by model number in the Audix DSP plugin. IN THE BOX • M70WD microphone • Knurled fastener • Seismic / restraint cable • Spec sheet • Installation guide THE AUDIX INTEGRATED MICROPHONE SYSTEM | DANTE–AES67 SWITCH DSP AUDIX DN4 M55WD

PoE switch (see DN4 guide). FIGURE 1 Determine the microphone placement, drill a 2 inch (51mm) hole in the ceiling tile or mounting surface. FIGURE 3 For seismic cable installation, wrap the cable through beam, eyebolt or hanger and cable stay barrel (see fi gure 4). Remove M70WD placement screw and place eyelet over hole and tighten screw. FIGURE 2 Remove the knurled ring from the module, insert the module through the hole and reattach the knurled ring. Connect RJ45 cable to the M70 module. FIGURE 4 Cable Stay Operation FIGURE 5 Connect up to 4 microphones via Cat5 - 7 to the Audix DN4 interface. INSTALLATION CABLE RELEASE PIN CABLE STAY BARREL CABLE

© 2019 Audix Corporation. Audix is a registered trademark of the Audix corporation. Specifications subject to change without notice. For service and warranty information, visit AudixUSA.com/service or call 800.966.8261 FIGURE 10 1. Mic ID will show model number by channel 2. Starting “state” LED color can be selected 3. Gain control 4. High pass filter 5. Low pass filter 6. See Q-SYS™ designer asset manager Audix help file for detailed instructions FIGURE 9 1. Open Dante controller to confirm discovery on your network 2. If using Q-SYS™ DSP open Designer Asset Manager and Dowload Audix Plugin 3. Open Audix Plugin 4. See Figure 10 for Q-SYS™ control and LED functions 5. For DSP’s currently without Audix plugin, audio channels can be routed through the Dante controller. 6. See tech support at audixusa.com for updated API / Plugin information FIGURE 8 Reinstall grille – do not overtighten. FIGURE 7 Remove grille by turning counterclockwise. Adjust the microphone to point to the desired direction or coverage area. OPERATION OVERVIEW FINAL ADJUSTMENTS 1 2 3 4 5