GHM GREISINGER EASYLOG 80IMP Series Installation And Operating Manual

page 14 of 16 Alarm function alarm points selectable within the display range and alarm delay adjustable from 0 to 500 min Nominal temperature 25 °C Operating temperature -25.0 … +60.0 °C Storage temperature -30.0 … +70.0 °C Housing ABS housing, transparent screen made of polyester Dimensions 48,5 × 48,5 × 35,5 mm (L × W × D) without sensor cable, angle-type plug and EASYBus plug. Protection rate IP65 (IP00 for open cable ends of connection cable) Electric connection (for input signals) approx. 0.5 m connection cable. cable assignm ...

page 5 of 16 3. Product description 3.1 Required accessory The EASYLOG 80IMP… is configurated, started and read-out via the EASYBus-interface. Therefore the following accessories are required:  Level converter - RS232 <> EASYBus (i.e. EBW 1, EBW 64, EBW 240) - USB <> EASYBus (i.e. EBW 3)  Connecting cable: level converter to EASYLOG  GSOFT 40K (version >7.14): Windows software to start the logger and read out the logger-data  EASYBus-Configurator (version >2.0): for the configuration of the extended settings 3.2 Notes on the logg ...

page 6 of 16 4. Display and control elements 4.1 Display  Main display  Secondary display  Display element for max / min   Logg: indicates that logger is recording    BAT: signals weak battery (see chapter 8).    AL: signals an alarm state at min- imum one channel  4.2 Function of the buttons (brief description) SET (button 1) • call menu Arrow key UP (button 2) • call / delete max-value Arrow key DOWN (button 3) • call / delete min-value SET 1 2 3 ...

page 16 of 16 12. Device options Additional information’s for options of the EASYLOG 80IMP/… 12.1 ALARM With the option „ALARM“ the device has an additional switching output (NPN) for the alarm function of the device. In result of the option there are following extensions: Device connection: Alarm output assignment of jack (view on pins) GND NPN Note to included alarm connection cable: GND: back + blue NPN: brown + white EASYBus assignment of jack (view on pins) EASYBus not used Connection examples: a.) General connection diagram for a r ...

page 8 of 16 6. Operation 6.1 Operating possibilities at the device - min/max value memory Function Procedure Display max-value Push button shortly The max-value is displayed for 4 seconds. (The max-value display function is signalled by the display el- ement “MAX”). Note: You can immediately deactivate the max-value dis- play by pushing the button again. Delete max-value Push button for about 5 seconds. “CLr” is displayed and the max-values of all measuring channels are deleted. Display min-value Push button shortly The min-value i ...

page 5 of 16 3. Product description 3.1 Required accessory The EASYLOG 80IMP… is configurated, started and read-out via the EASYBus-interface. Therefore the following accessories are required:  Level converter - RS232 <> EASYBus (i.e. EBW 1, EBW 64, EBW 240) - USB <> EASYBus (i.e. EBW 3)  Connecting cable: level converter to EASYLOG  GSOFT 40K (version >7.14): Windows software to start the logger and read out the logger-data  EASYBus-Configurator (version >2.0): for the configuration of the extended settings 3.2 Notes on the logg ...