Crossfire C3 102 Installation Manual

Connect to the anode of car battery Terminal to be connected with Remote cable which comes from the source and which controls the amplifier switching on Applied voltage must be between 7 and 15VDC Ground terminal Connect to the car chassis keep the length of the ground cable to a minimum REM GND +12V +12V Connect to 12V of battery with appropriate FUSE value. + REM GND Connect to remote turn on lead of source unit - Connect to chassis ground of vehicle* ELECTRICAL CONNECTION SPECIFICATIONS www crossfirecaraudio com . . www crossfirecaraudio com . . INSTALLATION MANUAL C3 102 Model RMS Power 13 8VDC Power 4 ohms 100W x 2 Power 2 ohms 150W x 2 Bridged Power 4 ohms 300W x 1 Min Speaker Impedance 2 ohm THD Distortion 0 08 IMD Distortion 0 08 Frequency Response 20Hz 20KHz Input Sensitivity 0 15V 8V Input Impedance 15K Signal to Noise Ratio 90 dB Channel Separation 50 dB Crossover Network Low Pass Filter 50Hz 500Hz Bass Boost 0dB 12dB High Pass Filter 50Hz 500Hz Fuse Rating 20A x 2 Size LxWxH 13 63x7 09x1 78 C3 102 @ @ @ @ . . . . - - . . . .

SYSTEM WIRING 1 CHANNEL BRIDGED MODE CONFIGURATION + + - - C3 102 R L R L + + - - C3 102 R L R L SPEAKER - + L - + R SPEAKER - + L - + R Connect to remote turn on lead of source unit - . Connect to remote turn on lead of source unit - . Speaker Impedance 2 4 ohm ~ Speaker Impedance 4 8 ohm ~