ArduCAM CC3200 Operation & User’s Manual
Text of the manual
CC3200 Camera Board User Guide
Restore to Factory Default
Introduction
This user guide helps user to restore the default firmware to the CC3200 camera board
when the camera failed to work with customer firmware.
Identify the Board Revision
There are two revision of CC3200 camera board, user can identify the revision from the
board PCB. And the default firmware is different, for revision A board please use the firmware
from
http://www.arducam.com/downloads/wifi_camera/factory_default/RevA/factory_default_reva.z
ip
for the revision B board please use firmware from
http://www.arducam.com/downloads/wifi_camera/factory_default/RevB/factory_default_revb.z
ip
Configure the UniFlash Setting
Unzip the files and open the ucf or usf file, modify the files path listed in the red box to your
own files path.
User need additional USB-Serial cable to download the firmware. Modify the COM port
number to your own USB-Serial port number. Connect the USB-Serial cable to the CC3200 camera
board TX/RX pins. Short the SOP2 jumper and press the reset button each time operation. Note
to remove the camera connector from the board when uploading the firmware.
