Argo Extreme 9 Service Manual

22 small increments while operating the unit. 12. Restart unit several times after allowing pressures to stabilize. Pinch off process tubes, cut and solder the ends. Remove pinch off tool, and leak check the process tube ends. 11.2.4 Special procedure in the case of compressor motor burnout. 1. Recover all refrigerant and oil from the system. 2. Remove compressor, capillary tube and filter drier from the system. 3. Flush evaporator condenser and all connecting tubing with dry nitrogen or equivalent, to remove all contamination from system. Inspect suction and discharge lin ...

10.7.1 Timer setting can be set 1-24 hours 10.7.2 During the unit operation, you can set numbers of hours. The unit will be auto switch off . If the unit is under the off mode, then the pre-setting is for on-operation and can be re-set for different 10.8 other controls 10.8.1 Water pump operation cycles 10.8.1.1 Under the cooling and dehumidifying mode, compressor will operating, then if the compressor off then the water pump will be off too. 10.8.2 water full protection functions with indicator (4 times at 8 seconds) When the ...

C: Under the condition of T1≤T -1℃,the compressor and internal motor system will be switching back to the original setting 10.5.1.3 Cooling mode, the inner motor can be set high, middle, low fan speed。 10.5.1.4 Cooling mode: The state of outer motor： A：when compressor is working, the outer motor is running accordingly. When compressor stop, the outer motor stop。 10.5.2 Dehumidification mode (DH display) 10.5.2.1 The set ...

22 small increments while operating the unit. 12. Restart unit several times after allowing pressures to stabilize. Pinch off process tubes, cut and solder the ends. Remove pinch off tool, and leak check the process tube ends. 11.2.4 Special procedure in the case of compressor motor burnout. 1. Recover all refrigerant and oil from the system. 2. Remove compressor, capillary tube and filter drier from the system. 3. Flush evaporator condenser and all connecting tubing with dry nitrogen or equivalent, to remove all contamination from system. Inspect suction and discharge lin ...

please also dismantle the screws at two sides Disassembly steps for water motor : please dismantle the screws of condensor,slide up the partition panel.and then slow take out the condensor from the left hand side.From there, you can see the water motor.Caution, please be note that in order to avoid any water split by water wheel, you should uphold the condensor screws Water motor Water wheel screws ...

W 870 Heating Power consumption W --- Cooling Rated current A 3.98 Cooling EER W/W 2.8 System data Refrigerant type g R410A/520g Design pressure (Hi/Lo) Mpa 5.5 Moisture Removal(30℃,RH80%) L/DAY 40 Indoor air flow (l.-m.-h.) m³/h 350-380-400 Sound pressure (l.-m.-h.) dB(A) 35-36-38 Dimension&Weight Dimension (WxDxH) mm 505x310x725 Packing (WxDxH) mm 575x350x880 Net/Gross weight kg 26.5/28.5 System Details Compressor Model KRRC072ELJC-A ...