AllMounts AS0946T Installation Manual

Tighten the two bolts by using a proper phillips screwdriver to secure the adapter brackets to the wall plate. wall INSTALLATION MANUAL ISSUED: APR.2013 7 Tilting Wall Mount CAUTION: DO NOT EXCEED RATED LISTED WEIGHT. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR! Maintenance • Check that the bracket is secure and safe to use at regular intervals(at least every three months). • Please contact your if you have any questions. distributor 4. Adjustment Loosen the adjusting knobs to tilt the TV to obtain desired angle then tighten them. 10° -15° Tilt adjusting knob 200x200/300x300 400x200/400x400 600x400 AS0946T 50kg (110lbs) RATED 50kg (110lbs) RATED 70" MAX wall

If any parts are missing or faulty, telephone your local distributor for a replacement. Package M Package W 1 NOTE: Read the entire instruction manual before you start installation and assembly. WARNING • Do not begin the installation until you have read and understood all the instructions and warnings contained in this installation sheet. If you have any questions regarding any of the instructions or warnings, please contact your local distributor. • This mounting bracket was designed to be installed and utilised ONLY as specified in this manual. Improper installation of this product may cause damage or serious injury. • This product should only be installed by someone with good mechanical ability who has basic building experience and fully understands this manual. • Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components. • If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. The use of a stud finder is highly recommended. • Always use an assistant or mechanical lifting equipment to safely lift and position the equipment. • Tighten screws firmly, but do not over tighten. Over tightening can cause damage to the items, This greatly reduces their holding power. • This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury. ST6.3x55 (x4) W-A concrete anchor W-B (x4) D6 (x4) W-C washer M5x14 M-A (x4) M6x14 M-B (x4) washer M-F (x4) M8x20 M-C (x4) big M-H spacer (x4) M6x30 M-D (x4) M8x30 M-E (x4) small spacer (x8) M-G wall plate A (x1) left bracket (x1) B adapter right bracket (x1) C adapter

finder is highly recommended. • Installers are responsible to provide hardware for other types of mounting situations. • Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components. 1a. For Wood Stud Wall Mounting Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components. WARNING 1b. For Solid Brick and Concrete Mounting Screw the wall plate onto the wall X X √ Screw the wall plate onto the wall X X √ 1 2 Drill pilot holes 3 Find and mark the exact location of mounting holes ø 4.5mm (ø 3/16") 55mm (2.2") 55mm (2.2" ) Drill pilot holes 1 2 Mark the exact location of mounting holes 60mm (2.4") 60mm (2.4") ø 10mm (ø 3/8" ) W-A W-C W-A W-C W-B X 600mm (23.6") Model Stud 406mm (16") 450mm (17.7") 610mm (24") AS0946T

TV TV TV 2-1. For Flat Back Screens TV TV 2-2 For Recessed Back Screens or to Access A/V Inputs TV Tighten all screws but do not over tighten. · Position the adapter brackets as close as possible to the center of the TV. · Screw the adapter brackets onto the TV. Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen. Top of the TV M-A/M-B/M-C M-F or or or M-C M-F M-G M-C M M / -D/ -E M-F M-G M-G M -D/M -E M-F M-H M -D/M -E M-F M-G M-H