Channel Actulux SVM 24V-5A Quick Start Manual

SVM 24V-5A Dane Mill Business Centre, Broadhurst Lane, Congleton, Cheshire, Cw12 1LA Tel: 01260 295106 Fax: 01260 291748 Email:[email protected] Quick Start Guide

LD2 Actuator closed or closing LD3 Weather sensor active LD4 Fault on actuator line LD5 Fault on call point line LD6 Fault on smoke sensor line LD7 Fault on BUS 2x12v 7Ah Batteries First and intermediate smoke detector(s) Last or only smoke detector (fit 10k end of line resistor) Single external call point (ensure J1 is fitted) First and intermediate actuator joint box Last or only actuator joint box (fit 27k end of line resistor) 230v Feed from a 5A supply Typical connections for a stand-alone system with built-in call point and 1 external call point Jumper settings for actuator line monitoring and end of line as shown DIP Switch settings (arrows show the direction the switch is set = ON) TAKE CARE TO OBSERVE CABLE CONNECTIONS IN EXTERNAL BREAK GLASS UNIT. 6 IN BREAK GLASS CONNECTS TO 15 IN PANEL 7 IN BREAK GLASS CONNECTS TO 14 IN PANEL * * Alternative connections for Hochiki SLV-E3(HFP) head and YBN-R/6SK(WHT) diode base If a link to a fire alarm system is required Link a normally open contact to terminal 16 & 17