Air Monitor CAMM Installation, Operation And Maintenance Manual

116-044-91.P65 (8/31/10) CAMM - IO&M Manual 40 5.14 – ENHANCED DISPLAY CONFIGURATION (con't) SECTION 5 – OPERATION * Available only if Square Root Function is ON.  Available only if Transmitter Flow is selected as Process Type.  Available only if Percent Deviation has been selected as a Special Function. PARAMETER LIST for Lines 2, 3, 4 and 5 PARAMETER DISPLAY IN "NORMAL" MODE NONE DIFF. PRESSURE * TRANSMITTER VELO  TEMPERATURE ABSOLUTE PRESSURE EXT. SPEC FUNC INPUT SPEC FUNCTION OUTPUT ALARM %DEV. SETPOINT  PERCENT OF PROCESS CUSTOM TEXT ...

116-044-91.P65 (8/31/10) CAMM - IO&M Manual 58 8 – TROUBLESHOOTING SECTION 8 – TROUBLESHOOTING Personnel should be familiar with the operation of the CAMM (see Section 5) before performing any troubleshooting. Problem No Display and "CPU Activated" LED is not lit. No output or incorrect output (Transmitter Output) and display responding correctly with process change. No output or incorrect output (Transmitter Output) and display not responding or correctly with process change. No output or incorrect output. (Temperature, Absolute Pressure, or Special Function). ...

116-044-91.P65 (8/31/10) CAMM - IO&M Manual 11 5.3 – NORMAL OPERATION Under Normal operation the CAMM's display will continuously indicate current process variables. AUTO-zero At periodical intervals* (see Factory Set-Up Information Sheet) the AUTO-zero cycle will be initiated. When this occurs, the display will be frozen and all outputs will remain constant. During this cycle the "AUTO-zero in Progress" LED will be lit. This cycle will not occur if AUTO-zero has been turned OFF in configuration programming (see Section 5.10). The AUTO-zero cycle can be manuall ...