Blaupunkt AVMC 1.0 Operating And Installation Instructions

according to established safety guidelines. However, dangers may still occur if the safety notes in this manual is not observed. This manual is intended to familiarize the user with the reverse camera important functions. Read this carefully, prior to using the product. Keep this manual in an easily accessible location. In addition, do observe the instructions of the devices used in conjunc- tion with this all-view monitoring camera. Attentions • • • • • • • • • • This manual may be updated from time to time without any notice CAUTIONS Disclaimer In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products. USA & CANADA: This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada. 1 Assign a mounting location that will not obstruct driver in any circumstances. Or cause injuries to drives and passengers in case of emergency brake or accidents. Ensure all wires are connected properly, and that the unit is functioning well before fitting the unit into the mount. Any unauthorized installation, disassembly or modification may cause malfunction to the unit and void warranty of the unit. Always use only the parts that are included with the units only. Do not damage vehicle components when drilling holes for the mount. Vehicle may differ from the description provided here. Consult an authorized Blaupunkt dealer or ve- hicle’s manufacturer if the information provided here does not fit your specific installation requirement. This unit is applicable for front, rear and side camera use. Consult an authorized Blaupunkt dealer during installation. Unit does not record video. Avoid automatic car wash or high-pressure water to prevent water and pressure from damaging the camera or causing it to fall off. Do not install this unit near heater outlet.

Dynamic Range Sync System Signal Noise Ratio Video Signal Exposure Control White Balance Illumination Min. Operating Voltage Power Input Range Operating Temperature Accessories IMX8307(Camera)+NVP2431(Processing) 1/3 inch (6mm) 1297x977=L27MP 1000 TVL 720p HD 60fps Support Standard Dynamic Range Internal ≥48dB 1.0Vp-p at 75ohm Automatic Automatic 0.001 Lux/F2.0 3.5V~5.5V 3.5V~5.5V -20~75°C Front & Rear Camera 4x Extension Cord (Yellow - 6.5m)/ (Red - 3.9m)/ (Blue - 4.0m)/ (Black - 4.0m) Hole Saw Rear Camera Bracket 3M Tape 4x Grommet Side Camera (Left/ Right) 1x Wire Hardness (0.2m) 4x Tapping Screws 4x Machine Screws

c) Side Camera b) Rear Camera 3 WIRING DIAGRAM INSTALLATION LOCATION HDMI 4G- 4G+ GPS WIFI BLACK Connect YELLOW RED BLUE BLACK YELLOW RED BLUE FRONT REAR LEFT RIGHT FRONT CAMERA REAR CAMERA LEFT CAMERA RIGHT CAMERA

Correction Calibration. • It is excluded in the packaging. CORRECTION CALIBRATION

view. Surround view does not show even after restarting the display monitor/ car radio. Surround view does not show even though power supplies of the reverse light or the rear car plate light is properly connected. Solution Restart the display monitor / car radio. Examine if the power supplies is properly connected. Examine if the power supply cables is damaged. Repair/ replace if the cables are damaged. If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.