Degelman PRO-TILL 30 Quick Start Manual

Maintenance (Check Machine Daily) A Connect Hydraulics WHEELS ROLLERS TRANSPORT WINGS JACK 3 5 4 2 1 5 4 1 3 2 FLOAT (if available) 143411 v1.1 QUICK-START GUIDE* for PRO-TILL 30/36 * Refer to operators manual for complete safety and operation info. T O B E E L I G I B L E F O R Y O U M U S T R E G I S T E R WARRANTY REMEMBER! You must complete Product Registration to be eligible for Warranty. GPS Reference (Set overlap to 6” per side) (with 20" discs) 2" Depth Pro-Till 30 352” (8.95m) Pro-Till 36 431” (10.95m) (with 20” discs) MAX Depth Pro-Till 30 355” (9.0m) Pro-Till 36 434” (11.0m) (Consider setting the GPS to include a 6” implement offset to the right) • Hydraulic Connections/Hoses • Working points & pins • Hubs, Spindles, & Tire Pressure: - End Wheels: 41 PSI (283 kPa) - Center (confirm tire type): 389 AGRIFLEX: 40 PSI (275 kPa) 382 FLOTRUCK: 58 PSI (400 kPa) • Check for missing, worn or damaged parts. * Refer to operators manual for complete safety and operation info. IMPORTANT: The Wing Cylinder Circuit includes a Down Pressure Valve. Operator must engage wing circuit hydraulics constantly in the extended direction to ensure constant down pressure. CONSTANT PRESSURE

Rear Disc Depth Adjustment (2 Outer Roller Frame Cylinders) 2 Front Disc Depth Adjustment (2 End Wheel Cylinders) 1 B Put in Field Position i) ii) iii) 1” 3 4 4 F MAX Transport Speed: 40 km/h (25 MPH) E Lower Wheels for Headland Turns. 1 PRO-TILL 30/36 Scraper Position Overview (Rubber Rollers) Set Gap distance at 1/4” to 3/8” from roller surface. Storage Position Maintenance Position Engaged Position Remove the 4 bolts to rotate into or out of “Storage position”, then re-install. Loosen the 4 bolts to rotate up into “Maintenance Position” & secure. Loosen the 4 bolts to rotate downward. Set the scraper clearance (1/4” to 3/8”). Properly tighten. D Test. Check. Adjust. 10-12 MPH 100m 100m (Ideal Operating Speed) C Set Cutting Depth (Start with 12 stops per cylinder, test depth & adjust) (IMPORTANT: Add depth stops starting from rod end) IMPORTANT: Re-phase and cycle oil in the Depth Control Cylinders before use. This is especially important after long periods of storage. 1 2 3 iv) v) 3 3 3 3 IMPORTANT: Operator must read and understand the tractor manual in order to place the required hydraulic circuits into float position or constant pressure position. 4 IMPORTANT: The Pro-Till model shown may differ, but the general procedure remains the same. (*Pro-Till 40 shown)