Damp2Dry PACD200 Operation & User’s Manual

• After starting operation, the display will show the humidity setting (left) and current humidity (right). Humidity setting can be changed by pressing “Up” or “Down.” • Time settings are based on minutes. For example, if the display shows “0000:50,” this means that the unit has worked for 50 minutes since powered on. If you want to view the total working time, press “T” again and the display will show this for 10 seconds, then return automatically to the original working hours. (Pressing “T” ...

-13- purCHase reCorD maInTenanCe reCorD Purchase Date: Serial Number: Distributor: Tel. DaTe serVICe performeD performeD by ...

To remedy the following errors, a qualified professional is required. noTe: With any error code, it is suggested to turn the unit off, wait five minutes, and then turn the unit on again. If the error code is still present, a qualified professional is required to fix the problem. CoDe meanInG DIsplay reaDInG soluTIon* E1 Coil sensor error Flashes every 30 seconds Replace coil sensor. Call for replacement part. E2 Humidity sensor error Flashes every 30 seconds Replace humidity sensor. Call for replacement part. E3 Low or ...

• After starting operation, the display will show the humidity setting (left) and current humidity (right). Humidity setting can be changed by pressing “Up” or “Down.” • Time settings are based on minutes. For example, if the display shows “0000:50,” this means that the unit has worked for 50 minutes since powered on. If you want to view the total working time, press “T” again and the display will show this for 10 seconds, then return automatically to the original working hours. (Pressing “T” ...

automatically. After use, press ON/OFF key to turn the unit off. Water pump will turn on automatically for 40 seconds to drain the remaining water in the unit, then turn off automatically. Key lock function If the keys of “T” and “P” are pressed for 2 seconds simultaneously, the defrost light will continue to illuminate at the speed of 50 Hz and all of the keys on the control panel will lock. The control panel can then be unlocked by pressing the “T” and “P” keys together again for 2 seconds. Vent ...

up to 16 ft vertically. Attempting to push water vertically more than 16 ft vertically may cause water backup in the pump, which can result in leakage. See image above. DraInaGe: The dehumidifier pump connects to a plastic drainage hose. The hose is stored on the back of the appliance. Uncoil the entire hose, ensuring there are no kinks or restrictions, and place the unattached end into a drain or run outdoors. Ensure that draining running to the outdoors does not create a hazard that could cause someone to slip. Water d ...

purGe: Press the key to empty water from the pump reservoir. During normal operation the pump purges automatically when the reservoir is full. Use “PURGE” before moving the machine to avoid water spillage. The pump will close automatically after 40 seconds of continuous operation. and : Press and keys to set or adjust humidity in the range of 26% and 90%. When the environmental humidity is below 26%, “CO” will be displayed. Defrost Indicator: The unit begins to defrost when the defrost indic ...