BE Deluxe Series Owner Manual & Operation Instruction

CONTROL 5. AC Circuit Breaker/RCD Protector The RCD/RCBO will automatically trip if has earth leakage has been detected to avoid electrocution, short circuiting of the load or overload. If the circuit breaker or RCD is switched OFF, switch the circuit breaker ON for power to the outlets. NOTE: generators fitted with RCD will be fitted with an M.E.N Link in the alternator or behind the control panel. 6. Ground Terminal This ground terminal is dedicated to reliably grounding the whole generator. 7. Oil Alert System The oil alert system is especially designed to prevent engine damag ...

SAFETY MESSAGES Your safety and the safety of others are very important. We have provided important safety messages in this manual and on the generator. Please read these messages carefully. A safety message alerts you to potential hazards that could hurt you or others. Each safety message is preceded by a safety alert symbol and one of three words: DANGER, WARNING, or CAUTION. Meaning as follows: You WILL be KILLED or SERIOUSLY HURT if you don’t follow instructions. You CAN be KILLED or SERIOUSLY HURT if you don’t follow instructions. You CAN be HURT if you don’t follow instr ...

(6) Turn the choke lever to “OPEN” position after the engine is warm. Turn the GENERATOR switch to Start position and hold for no more than 5 seconds or damage may be caused to the starting motor. If starting fails, release the switch and wait for 10 seconds before operating it again. If the speed of the starting motor drops fast after a period of time, it suggests the battery should be recharged. 7. STOPPING THE ENGINE (1) Turn the AC circuit breaker to the OFF position. (2) Turn the generator switch to the OFF position. (3) Turn the fuel valve to the OFF position. To stop the ...

�������������������������������������� Stop the engine before refueling ����������������������������������������������������������������� 2. Special Requirements · Electrical equipment,including lines and plug connections should be free from being bare. · The circuit breakers should match with the generator equipment. If the circuit breakers require replacement, they must be repl ...

������������������������������������������������������� (3) Reinstall the o-ring, and strainer and screw back the sediment cup. (4) Turn the fuel valve ON and check for leaks. 4. Spark Plug Service Recommended spark plugs: F7RTC or other equivalents (1) Remove the spark plug cap. (2) Use the plug wrench to remove the spark plug. (3) Visually inspect the spark plug to see if the insulator is cracked, if so, replace it with a new the spark plug. (4) Measure the plug gap with a ...

6. STARTING THE ENGINE 1. Recoil Starter (1) Remove all the loads from the output side. (2) Turn the fuel valve to the “ON” position. (3) Turn the AC circuit breaker to the“OFF” position. (4) Turn the choke lever to the“CLOSE” position. Don’t close the choke when starting the engine in warm state (5) Turn the generator switch to the “ON” position. (6) Pull the starter grip until a resistance is felt,then pull it out briskly. (7) Turn the choke lever to the“OPEN” position after the engine is warm. (8) Don’t use electric apparatus before setting circuit breaker ...