Caraudio-Systems r.LiNK RL-PCM3-2-TF Manual 

It is necessary to code the ParkAssist of the PCM 3.1 to retrofit factory PDC. 1. Turn on ignition 2. Wait until the head-unit has booted 3. Press and hold steering-wheel button BACK 4. Press and hold steering-wheel button ACCEPT (observe the sequence!) 5. Hold both buttons. During configuration the red and blue LED are blinking inside the CAN-box (visible at the male 8pin Molex connector). The PCM makes a reset after 5-10 sec. 6. Disengage both steering-wheel buttons 7. The red an ...

connector of the head unit. 3.2. Connections to after market rear-view camera Connect the video RCA of the rear-view camera to the female RCA connector with the label „Rear-view camera“ of RLC-POR03-2 harness. Connect the green cable of harness RLC-POR03 to the camera power supply (+12V max 1A). The green cable is high when reverse gear is engaged (if ignition is off, too). The power will be deactivated from a speed of 20 km/h. Note: Only compatible with NTSC-cameras. 3.3. C ...

Stand-by power drain <2mA Operation power drain ~60mA Power consumption ~0,08W Temperature range -30°C to +80°C Weight 44g Measurements (box only) W x H x D 70 x 20 x 47 mm/ 76 x 27 x 54 mm 7. Technical support Caraudio-Systems Vertriebs GmbH manufacturer/distribution In den Fuchslöchern 3 D-67240 Bobenheim-Roxheim email [email protected] Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ® of their corresponding legal owners. ...

Connect the video RCA of the front camera to the female RCA connector with the label „Front-view camera“ of RLC-POR03-2 harness. Connect the white cable of harness RLC-POR03-2 to the camera power supply (+12V max 1A). The white cable is high when reverse gear is engaged (if ignition is off, too). The power will be deactivated from a speed of 20 km/h. Note: Only compatible with NTSC-cameras. 2 1 ...

Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. 1.1. Delivery contents 1.2. Check compatibility of vehicle and accessories Take down the SW-version and HW-version of the interface boxes, and store this manual for support purposes. Requirements Vehicle Porsche Cayenne, Panamera, 911, Boxster, Cayman, Macan Navigation PCM 3 (only Cayenne version) , PCM 3.1 (911, Boxster and Cayman only from software version 4.xx) ...

connector of the head unit. 3.2. Connections to after market rear-view camera Connect the video RCA of the rear-view camera to the female RCA connector with the label „Rear-view camera“ of RLC-POR03-2 harness. Connect the green cable of harness RLC-POR03 to the camera power supply (+12V max 1A). The green cable is high when reverse gear is engaged (if ignition is off, too). The power will be deactivated from a speed of 20 km/h. Note: Only compatible with NTSC-cameras. 3.3. C ...