Eaton Eaton 5PX Advanced User's Manual

① Load status and measurements ② Equipment status icon ③ Status / Message ④ Battery status As default, or after 5 minutes of inactivity, the LCD displays the screen saver. The backlight LCD automatically dims after 5 minutes of inactivity. Press any button to restore the screen. Note. If other indicator appears, see troubleshooting page for additional information. The following table describes the status information provided by the UPS : Operation status Possible cause Action Standby mode The UPS is OFF, waiting for start-up command from user Equipm ...

protected] [Load powered] [General alarm] [OVL pre- alarm] [DB9-8]: [On bat] [Low bat] [Bat fault] [UPS OK] [Load protected] [Load powered] [General alarm] [OVL pre- alarm] Remote command [Yes] [No] If Enabled, shutdown or restart commands from software are authorized. [Yes] Shutdown commands [Send CMD] [Output OFF] [OFF delay] [restart] Sets events or fault that will actuate Output signal parameters through external contact connector or RS232 port [Send CMD]: [Yes] [No] [Output O ...

mode Model Current limitation 1000 31A 1500 38A 2200 38A 3000 64A Transfer time Utility Outage: 1-4ms for normal mode,  >5ms for sensitive mode Utility abnormal: <10ms for normal mode ,<25ms for sensitive mode 8.6 Electrical output connection Catalog Number Output conection Output cable 5PX1000IRT2UG2 (4) IEC10A Primary group (2) IEC10A Group 1 (2) IEC10A Group 2 (2) IEC10A 5PX1500IRT2UG2 5PX2200IRT2UG2 (4) IEC10A + (1) IEC16A Primary group (2) IEC10A + (1) IEC16A Group 1 (2) IEC10A Group 2 5PX220 ...

module to the AC power source using the cable (13) supplied. 2.  Connect the UPS input socket (2) to the “UPS Input” (47) on the HotSwap MBP module, using the cable (26) supplied. This cable and the connector are marked blue. 3.  Connect the UPS outlet (3) to the “UPS Output” (46) on the HotSwap MBP module, using the cable (26) supplied. This cable and the connector are marked in red. 4. Connect the equipment to the outlets (42) on the HotSwap MBP module. These outlets differ, depending on the version ...