Bard WH302D Installation Instructions Manual

Models WH302D WH362D INSTALLATION INSTRUCTIONS © Copyright 2003 Manual : 2100-442 Supersedes: File: Volume III Tab 17 Date: 10-23-03 Bard Manufacturing Company Bryan, Ohio 43506 Since 1914...Moving ahead just as planned. ...

Wall Mount General Information Wall Mount Nomenclature ....................................... 2 Shipping Damage .................................................... 5 General ................................................................ 5 Duct Work ........................................... ...

Manufactured under the following U.S. patent numbers: 5,485,878; 5,301,744; 5,002,116; 4,924,934; 4,875,520; 4,825,936 For more information, contact these publishers: ACCA Air Conditioning Contractors of America 1712 New Hampshire Ave. N.W. Washington, DC 20009 Telephone: (202) 483-9370 ...

Heat Pump Wall Mount Model Nomenclature WH 30 2 D A 10 X X X X X B TABLE 1 ELECTRIC HEAT TABLE odels M W K WH302DA WH302DB WH302DC WH362DA WH362DB H362DC W 240-1 208-1 240-3 208-3 460-3 240-1 208-1 240-3 208-3 60-3 4 A BTU A BTU A BTU A BTU A BTU A BTU A BTU A BTU A BT ...

Based on 75°C copper wire. All wiring must conform to NEC and all local codes. Maximum KW that can operate with heat pump on. These Minimum Circuit Ampacity" values are to be used for sizing the field power conductors. Re ...

checked for external signs of shipping damage. If damage is found, the receiving party must contact the last carrier immediately, preferably in writing, requesting inspection by the carrier’s agent. GENERAL The equipment covered in this manual is to be installed by ...

All units are built with fresh air inlet slots punched in the service panel. If the unit is equipped with the fresh air damper assembly, the assembly is shipped already attached to the unit. The damper blade is locked in the closed position. To allow the damper to operate, the maximum and minium blade position s ...

1. Two holes, for the supply and return air openings, must be cut through the wall as shown in Figure 3. 2. On wood-frame walls, the wall construction must be strong and rigid enough to carry the weight of the unit without transmitting any unit vibration. See Figures 5 and 6. 3. ...

Side section view of supply air duct for wall mounted unit showing 1/4 inch clearance to combustible surfaces. MIS-277 MIS-311 NOTE: It is recommended that a bead of silicone caulking be placed behind the side mounting flanges and under the top flashing at the tim ...