Sunricher SR-2803a Quick Start Manual

09.2803A.04459 Switch between single color mode or dual color mode: Single color mode: (e.g. zone 4), press and hold down 4 then zone 4 was under single color mode. Under this model, and will not working. Dual color mode: Choose a zone(e.g. zone 4), press and hold down 4 & together about 5-10 seconds, then zone 4 was under dual color mode. Choose a zone & together about 5-10 seconds, Note:Before the first use, please remove the protective film on the battery. Function introduction Important: Read All Instructions Prior to Installation Output RF signal Operation Frequency 868/915/434MHz Operating temperature 0-40°C Relative humidity 8% to 80% Dimensions 136.3x38.9x10.7mm Front side Back side • Control 6 zones of receivers separately • Single color/dual color controller • Compatible with all universal series RF receivers • 1 receiver can be paired by max 8 different remote controls. • Waterproof grade: IP20 Product Data • This device contains a button lithium battery that shall be stored and disposed properly. • DO NOT expose the device to moisture. Safety & Warnings Power Supply 3V(1xCR2025 battery) Control the receiver’s channel 1 and channel 3. Press and hold down to adjust warm white between 0%-100% Only work with dual color, it's useless for single color. 6 zones control. Click to choose the zone, Press and hold down to turn on/off the zone Control the receiver’s channel 2 and channel 4. Press and hold down to adjust cool white between 0%-100% Only work with dual color, it's useless for single color. On/Off Press and hold down to increase light intensity smoothly Press and hold down to decrease light intensity smoothly 1 2 1 Pair with RF receiver Step 3:Choose and click a zone number(e.g. zone 4) Step 2:Click the “Learning Key” button on RF receiver to set it into pairing status Note: one receiver can be paired with max 8 remote controls. Learning Key RF LED Receiver Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the instruction of RF receiver that you would like to pair with. Step 4:Click any of the four buttons , LED lights connected with the RF receiver flicker once means the receiver is paired with zone 4 successfully.

Option 1: have all the receivers in the same zone, like zone 1 Learning Key RF LED Receiver Zone 1 Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4 Zone 1 Zone 2 Zone 3 RF remote RF remote Learning Key RF LED Receiver Learning Key RF LED Receiver Learning Key RF LED Receiver Learning Key RF LED Receiver