Sunnydaze Decor DW-662 Manual 

of the items we sell. Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof of purchase, with the date of purchase as well as photos of the merchandise defect, must be provided. Photos are used to determine the cause of defects and for future quality control. If you have any questions, comments or concerns, feel free to contact us by phone at 888-881-4668, by email: [email protected], or via our contact us page at www.SerenityHealth.com/contact-us/ PREPARATION: Before beginning assembly, read all warnings and safety precautions. WARNINGS & CAUTIONS: WARNINGS: To reduce the risk of electric shock, only connect the pump to a Ground Fault Circuit Interrupter (GFCI) outlet. Do not exceed the voltage shown on the pump. Always disconnect the pump from the power source before performing any maintenance or work on the pump, light(s) or any fountain fittings. Inspect the power cord for damage before installation and maintenance. If damage to the pump is found, it should be replaced. CAUTIONS: Use a proper power source as indicated on the pump label. Keep the cords away from high temperatures and heat sources. Do not lift the pump by its power cord. Keep the fountain out of reach of children. Do not let the pump run dry. The pump must be completely submerged for proper operation and cooling. Do not pump heated liquids. Operate with freshwater only. Avoid heavily chlorinated water and water with high PH levels. Do not use harsh chemicals such as bleach to clean the pump. 03/2019 DW185111 1 WINDING SHOWERS TABLETOP FOUNTAIN WITH LED LIGHT DW-662 Read this manual carefully before beginning assembly. Keep these instructions for future reference. Assemble components of this fountain on a soft, clean surface to avoid scratching or damaging the finish.

It may take several minutes for the air to escape and water begins to flow. TROUBLESHOOTING • Ensure that the pump is fully submerged and add water to the basin if necessary. • Check to make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician. • Check the pump and tubing for obstructions. • Check the flow control on the body of the pump as it may need to be adjusted to achieve the desired flow rate. • If the light is not working, ensure the cables are fully connected, and the seal is adequately tightened (do not over-tighten). • If water is not flowing within several moments of the fountain being plugged in, unplug the power supply for a few moments and plug it back in; the pump may have air bubbles in the filter which can prevent water from circulating properly. IMPORTANT INFORMATION USE & CARE • For indoor use only. • Check the water level frequently to ensure the pump remains fully submerged; never allow the pump to run dry as it will burn out the motor. • Only use water in this fountain; distilled water is recommended to prevent mineral buildup. • Periodically change the water to keep the water, fountain and pump clean. Remove scale and build-up regularly. DO NOT use harmful additives such as bleach, chlorine, etc. DO NOT use anything abrasive to scrub the fountain. • Always shut off the power supply before cleaning and maintaining the fountain and the recirculating pump. • Take care when handling the pump; only pick it up by the body of the pump, never the power cord. Any modification or failure to follow the recommended care will void the product warranty. 3 2 Assemble components of this fountain on a soft, clean surface to avoid scratching or damaging the finish. ASSEMBLY: 1. Connect the electric submersible pump to the tubing that is inside the fountain. 2. Connect the shorter pump cable to the LED light and place the light in the basin of the fountain. 3. Connect the longer pump cable to the AC adapter. 4. Fill the fountain with enough water to keep the pump fully submerged during operation. 5. Place the splash screen onto the fountain basin. 6. Plug the power cord into a properly grounded GFCI outlet. 1 2 1 3 4 5 6