SUHNER UXJ 2 Technical Document

Technical Document Translations of the «Original-Betriebsanleitung» DE FR GB UXJ 2 ...

3.1 Protection devices 3.2 Grinding tool 3.3 Working instructions 4. Maintenance 4.1 Maintenance preventive 4.2 Servicing and wearing parts 4.3 Repair 4.4 Warranty 4.5 Storage 4.6 Disposal / Environmental com- patibility 1. Notes on safety 1.1 General safety informations 1.2 Use of the machine for pur- poses for which it is intended 1 ...

mations This operation manual is appli- cable solely for the machine UXJ 2. The machine may be used by qualified personnel only. WARNING Read all safety instructions and all instrustuctions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions f ...

sidual current device (RCD) pro- tected supply. Use of an RCD reduces the risk of electric shock. 3) Personal safety a) Stay alert, watch what you are do- ing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alco- hol or medication. A moment of in ...

a) Do not force the power tool. Use the correct power tool for your ap- plication. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be r ...

purposes for which it is intended •� The�machine�use�of�this� machine is the wet and dry grinding and the polishing of artificial or natural stone with the use of grinding discs, rings and wheels. •� This�machine�is�also�suited� for the polishing and brush- ing of surfaces without the use of water. •� ...

formity Otto Suhner GmbH of Trottäck- er 50, D-79701 Bad Säckingen, hereby declares under sole responsibility that the product with the serial or batch no. (see reverse side) complies with the requirements under the Direc- tive 2004/108/EC, 2006/42/EC, 2011/65/EU. Applied stand- ards: EN ISO 12100, EN 60745, EN 55014-1, EN 55014- ...

This information is very impor- tant for ensuring correct opera- tion of the product. Failure to ob- serve this information can result in a defect. Note on safety / Warning This information serves to achieve safe operation. Fail- ure to observe this information may compromise the operator‘s safety. Informatio ...

vice Contrôler la tension du réseau. La tension de la source doit cor- respondre avec les indications de la fiche signalétique. Avant le raccordement de la machine au réseau, s’assurer que l’interrupteur EN/HORS soit déclenché. Le disjoncteur différentiel à cou- rant résiduel (DDR) ne doit pas être immergé ou reposer ...

OFF» Again insert the PRCD plug into the power socket. Press the «RESET» button. The display switches to «RED ON» 3) Press the «TEST» button. The display switches to «BLACK OFF» Press the «RESET» button. The display switches to «RED ON» This protective equipment pro- tects against malfunctions in the ...