D-Link DGS-1100-24 Manual 

Appendix B - Technical Specifications VLAN Hardware Specifications Key Components / Performance Switching Capacity: - DGS-1100-16: 32Gbps - DGS-1100-24: 48Gbps Max. Forwarding Rate: - DGS-1100-16: 23.8Mbps - DGS-1100-24: 35.7Mbps Forwarding Mode: Store and Forward Packet Buffer memory:3.5 Mbits Flash Memory: 2M Bytes Port Functions 16/24 10/100/1000BaseTX ports compliant with the following standards: - IEEE 802.3 - IEEE 802.3u - IEEE 802.3ab - Supports Full/half-Duplex operations at 10/100Mbps - Supports Full-Duplex operation at 1000Mbps Physical & Environm ...

Select the event message(s) to be sent out to the managing station. System Event: The system level messages contain: Device Bootup - System boot-up information Illegal Login - Events of incorrect password logins and records the IP of the source PC Twisted pair Port Link Up/Link Down: Copper port connection information Firmware Upgrade State: Information of firmware upgrade - success or failure System > Password Access Control Setting a password is a critical tool for managers to secure the EasySmart Switch. After entering the old password and the new passwor ...

Figure 55 – QoS > Bandwidth Control From Port / To Port: A consecutive group of ports may be configured starting with the selected port. Type: This drop-down menu allows you to select between RX (receive), TX (transmit), and Both. This setting will determine whether the bandwidth ceiling is applied to receiving, transmitting, or both receiving and transmitting packets. No Limit: This drop-down menu allows you to specify that the selected port will have no bandwidth limit. Enabled disables the limit. Rate: This drop-down menu allows you to select data rate ...

Figure 21 – Multi Firmware Upgrade DHCP Refresh: If a DHCP-client enabled switch in the Device List shows the default IP is still used, it means the device did not receive an IP address from the DHCP server successfully. Select that switch and click the DHCP refresh icon. Enter the correct Device Password and then click OK. The device will renew the IP address from the DHCP server. Figure 22 – DHCP Refresh Web Access Select a switch from the Device List. Click this icon to launch your internet browser (eg. The Internet Explorer). Here you can configure t ...

NOTE: Please be sure to uninstall any existing SmartConsole Utility from your PC before installing the latest SmartConsole Utility. n 1: Follow these steps to install the SmartConsole Utility via the autorun program on the installation Drive. e ”Install SmartConsole Utility” button and an installation wizard will guide you through the nsole Utility, you can open the utility by clicking Start > e L2 network segment of your PC and use the SmartConsole Utility to discover the Smart Switches. manually. le Utility\setup.exe (where D:\ represents the drive o ...

Figure 43 – L2 Features > Loopback Detection Loopback Detection State: Use the drop-down menu to enable or disable loopback detection. The default is Disabled. Interval (1-32767): Set a Loop detection Interval between 1 and 32767 seconds. The default is 1 seconds. Recover Time (0 or 60-1000000): Time allowed (in seconds) for recovery when a Loopback is detected. The Loop Detection Recover Time can be set at 0 seconds, or 60 to 1000000 seconds. Entering 0 will disable the Loop Detection Recover Time. The default is 60 seconds. From Port: The beginning of a ...