Dish Network 159263 Operation & User’s Manual
Text of the manual
To read out your remote codes, see page 8 for instructions.
If you enter a “1” as the last number of your code,
your remote is in Limited Mode (see page 3 for more details).
Auxiliary Equipment Code
Refer to page 9 for detailed instructions on Learning
Refer to page 11 for detailed instructions on System Wizard
Learning and System Wizard
Separate the key
from the remote
by inserting
your thumbnail
or a coin in the
crease. Remove
the key by
grasping at
the bottom.
Insert the
key face up
and slide
into place.
Pull the
remote
battery
cover off.
Note: If you will be using the blue TV2 key that comes
already installed in your remote, skip this step and
proceed with the next step (Insert the Batteries).
Install the Key Correctly
1
Insert the Batteries
2
1
4
2
1
Replace
the
remote
battery
cover.
Insert 4 AAA
batteries,
making sure
to match the
plus (+) ends
with the plus
markings on
the battery
case.
2
Quick Setup
3
Change the
UHF/IR
SWITCH
to IR
Confirm that your remote operates your
receiver by pressing remote buttons. If
your remote has a blue number 2 key, you
may need to go to your remote TV2 location to
confirm your remote operates your receiver.
If this is not working, go back to step 5.
Making the Remote Work
With Your Receiver
3
6
RECORD
Turn your receiver and
TV on, and press
SYSTEM INFO on the
front of the receiver.
Confirm that you
see the System
Information screen.
Press RECORD on
your remote. The remote
address will probably
change on the screen.
3
2
1
5
4
REMOTE
ANTENNA
Verify the UHF antenna
is installed on the back
of the receiver. Verify
the UHF/IR Switch
is set to UHF.
If you installed this key,
continue with step 2 on this page.
If you installed this
key, go to page 14
inside this guide.
