Winners Only BTB Assembly Instructions

WINNERS ONLY R ASSEMBLY INSTRUCTIONS Allen Bolts Flat Washer HB Left Leg Slat Support Leg Slat Support Leg STEP 1: Attach the Wood Stretcher (D) to both Headboard Legs (A&B) using provided hardware as shown on FIG.1 Caution: Please read instructions thoroughly before unpacking assembly parts. Sharp, exposed staple tips can cause injury. Therefore, for your protection, please remove any exposed staples used in packing. Please keep all hardware parts out of the reach of children. 1. We recommend that you should assemble this product with the assistance of another person; this will make assembly easier and will help to eliminate damage to the product or injury to persons during assembly. 2. Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during shipment. 3. Please do not over tighten screws or bolts. 4. Please put all parts on a non-abrasive floor before assembly, and follow the assembly steps to assemble your newly purchased product correctly and efficiently. PROD.NO : BTG/BTH/BTP1001Q PROD.NO : BTB/BTG/BTH/BTP1001F

ASSEMBLY INSTRUCTIONS Page 2 of 3 STEP 3: Attach both Bed Rails (F) to the Headboard assembly (A,B,D&C) using the provided hardware as shown on FIG.3 STEP 3: Attach both Bed Rails (F) to the Footboard (E) using the provided hardware as shown on FIG.4 STEP 2: Attach the Headboard (C) to the Legs assembly (A,B&D) using provided hardware as shown on FIG.2 PROD.NO : BTG/BTH/BTP1001Q PROD.NO : BTB/BTG/BTH/BTP1001F

WINNERS ONLY R ASSEMBLY INSTRUCTIONS STEP 5: Attach Support Legs (H) to Slats (G)as shown on FIG.5. STEP 6: Attach Slats with Support legs (G&H) to the Side Rail (F) using the provided hardware as shown on FIG.6 Assembly is now completed. PROD.NO : BTB/BTG/BTH/BTP1001F PROD.NO : BTG/BTH/BTP1001Q

WARNING: Before the removal or installation of charging kit disconnect charging kit from any electrical outlets. Fig.1 STEP 2: Attach charging kit on the desired headboard leg using 2 screws and phillips screwdriver as shown in Fig. 3. Step 1: Using a phillips screwdriver remove the 2 screws attaching the charging kit to headboard leg as shown in Fig.1. BTB/BTG/BTH/BTP1001F BTB/BTG/BTH/BTP1001T Charging Kit Removal And Installation. Note: The Manufacturing label should not be visible once charging kit is installed as shown in Fig. 2. Fig. 3 Fig.2. R