Viqua Sterilight PLATINUM SPV410-IHS22 Owner's Manual

disinfection system. The following levels are recommended for installation: • Iron: < 0.3 ppm (0.3 mg/L) • Hardness*: < 7 gpg (120 mg/L) • Turbidity: < 1 NTU • Manganese: < 0.05 ppm (0.05 mg/L) • Tannins: < 0.1 ppm (0.1 mg/L) • UV Transmittance: > 75% (call factory for recommendations on applications where UVT < 75%) * Where total hardness is less than 7 gpg, the UV unit should operate efficiently provided the quartz sleeve is cleaned periodically. If total hardness exceeds 7 gpg, t ...

Notre engagement VIQUA s’engage à assurer que votre expérience avec ses produits et son organisation dépasse vos attentes. Nous avons fabriqué votre système de purification aux UV selon les normes les plus élevées de qualité et nous sommes fiers de vous compter parmi nos clients. Si vous avez besoin de soutien ou avez des questions au sujet de votre système, veuillez contacter notre équipe d’assistance technique au 1.800.265.7246 ou à [email protected] et nous nous ferons un plaisir de vous venir en aide. Nous espérons sincèrement que vous appr ...

it shouldn’t be part of your system. WATER CONFIDENCE Each component of your VIQUA system has been designed and developed through extensive research and development to be part of an overall system that operates safely and efficiently over its entire lifetime. get genuine Sterilight lamps are: Safety certified. Replacement with any other lamp voids NSF 55 and UL/CSA/CE certification and compromises safe lamp performance. Using non-genuine lamps results in electrical code no longer being met and safety is at risk. VIQUA systems are third-party validated ...

disinfection system. The following levels are recommended for installation: • Iron: < 0.3 ppm (0.3 mg/L) • Hardness*: < 7 gpg (120 mg/L) • Turbidity: < 1 NTU • Manganese: < 0.05 ppm (0.05 mg/L) • Tannins: < 0.1 ppm (0.1 mg/L) • UV Transmittance: > 75% (call factory for recommendations on applications where UVT < 75%) * Where total hardness is less than 7 gpg, the UV unit should operate efficiently provided the quartz sleeve is cleaned periodically. If total hardness exceeds 7 gpg, t ...

5.9 gpm (22.6 lpm) (1.3 m3/hr.) UV Intensity Monitor yes Flow Pacing yes Elapsed Time Meter Countdown yes Total Hours yes Flow Restrictor yes Dry Contacts yes Safety Interlock yes Lamp Replacement Reminder yes Diagnostic Check yes Communication Port yes Reactor Chamber Material 316 L SS Electropolished & Passivated yes Electrical Volts 90-265V/50-60Hz. Power Consumption 60 W Lamp Watts 46 W Maximum Operating Pressure 8.62 bar (125psi) Ambient Water Temperature 2-40˚C (36-104˚F) Maximum Ambient Temperature 40˚C (104˚F) Overal ...

information is relayed to the Platinum ICE controller and is displayed in “% UV Output”. The intensity is displayed by pressing the push-button switch a single time. The intensity is displayed as follows: (Note: “H” indicates unit operating in full power mode, “L” indicates unit is operating in reduced power mode. System will not switch to reduced power mode if water temp is below 20˚C or UV level drops below 55%.) 12 UV level between 65 to 100%....the system is functioning within no ...