Traeger 946282 Manual 

We recommend consulting a professional if you are unfamiliar with installing hardware �xtures. Signature Hardware accepts no liability for any damage to the handle, lock set, or door, or for personal injury during installation. Observe all local plumbing and building codes. Unpack and inspect the product for shipping damage. If any damage is found, contact our Customer Relations team at 1-866-855-2284. Ensure that you have gathered all the required materials that are needed for the installation. T R A EG E R ENTRANCE DOOR SET SKU: 946282, 946281, 946294, 946295 REVISED 02/06/2020 TOOLS AND MATERIALS: Safety Glasses Tape Measure Wood Chisel Drill Phillips Screwdriver Allen Wrench For Warranty information, please visit: signaturehardware.com/services/warranty

on the template. 4. Insert the handle latch bolt (B), and deadbolt latch bold (C) into the side of the door and adjust as neces- sary to �t your installation. 5. If the latch bolt face plates are not �ush with the door, carefully chisel out (mortise) some of the door as necessary. 6. Drill pilot holes, if necessary and secure the face plates to the side of the door with the provided mounting hardware. 7. Test �t the deadbolt cylinder (E) and interior hardware and exterior hardware to gain a better understanding of how the pieces �t together. 8. With all hardware pieces in place, insert and tighten the long screws from the back of the door. Hold the interior knob of the deadbolt in place, and tighten the small screw to secure. 9. Use an Allen wrench to loosen the set screw on the interior knob. Adjust the length of the spindle for your door, and tighten the set screw.. 1. If replacing an entrance with the same mounting hole speci�cations, move on to step 4. 10. Hold the handle latch bolt in, and insert the spindle through the door. Fit the outside door knob hardware into the latch bolt assembly. Insert the inside door knob hardware, �tting the inside knob over the spindle and aligning the screws holes. Tighten the mounting screws to secure. 11. To install the strike plates (A & D), mark the ends of the latch bolts with lipstick or paint. Close the door, and turn the deadbolt and handle several times to mark the door frame. 12. If necessary, mortise the areas around the holes so the strike plates are �ush with the door frame. 13. Secure the strike plates to the door frame with the mounting hardware. 2. Hold the template (if included) in place and mark the mounting hole locations on the front, and side of the door. If no template is provided, use the hardware as a guide to mark the mounting holes. T R A EG E R ENTRANCE DOOR SET SKU: 946282, 946281, 946294, 946295 A B C D E