Weaver Trimming Stand Assembly Instructions

WeaverLivestock.com FIGURE A FIGURE 1 FIGURE 2A FIGURE 2B ASSEMBLY IN THE BOX: • The trimming stand includes two separate components: a folded base-structure (legs assembled, folded and locked in place) and headpiece (chain attached). Figure A FOR ASSEMBLY: • Begin with folded structure face down on its top. Figure 1 • Remove pin from center brackets to unlock legs from the folded position. Figure 2a & 2b Pin Pin CONTINUED ON PAGE 2 1

• Extend legs to outright position, align cross-support bars with center brackets and replace the pin to lock cross-support bars into place. *Be sure to lock pin into place with wire snap. Figures 3a, 3b, 3c, 3d FIGURE 3A FIGURE 3B FIGURE 3C FIGURE 3D FIGURE 4 FIGURE 5 FIGURE 6 • Flip structure upright onto legs. Figure 4 • To assemble headpiece: first loosen thumbscrews to ensure smooth insertion. Figure 5 • Insert headpiece shaft into slot, adjusting for desired height, and tighten thumbscrew to lock into place. Figure 6 ** Ensure correct headpiece attachment – wide opening of jaw bars facing inward. (See Figure 6) WeaverLivestock.com

tighten thumbscrews to lock into place. Figures 7a & 7b • Plastic chain wraps around headpiece for safe storage and is secured with a square hook. Figure 8 **For replacement head chain, see: Trimming Stand Headpiece Conversion Kit (80-1060-BK). Plastic Goat Chain (80-1020-WH), (80-1021-WH), or (80-1022-WH) FOR DISASSEMBLY: • Ensure adjustable front legs are fully collapsed and tightened in place. • Remove headpiece from slot and place off to the side. • Flip the stand over onto top for easy access to folding mechanisms. • Remove pin from center brackets to release cross-support bars. • Fold legs in, ensuring that the cross-support bars fold under the leg frames and rest in the center brackets. Replace pin and lock with wire snap to secure legs in folded position. Figures 9a & 9b • For safe and easy headpiece storage, insert shaft into slot so that headpiece lies across the folded structure (not outwards) and tighten into place with thumbscrew – it should be flush with the platform and not sticking out. We recommend that the stand and headpiece be stored together and attached as such. Figure 10 DISASSEMBLY 20-3590-LV-OTR 3 WeaverLivestock.com ** The minimum animal height measurement is 30-1/2", measured from top of platform to jaw bars – to reflect animal height from hoof-to-jaw. Headpiece adjusts for increased height requirements.