Sega Giant Plants vs Zombies The Last Stand Manual 

cloth dipped in water. DO NOT use any diluted chemical detergent or cleansing agent as this will impair the workings of the component. Open the reject gate to gain access to the rundown path. Remove the dirt and stains from the runway by wiping off with a soft damp cloth. After wiping off as per previous step, further apply a dry cloth to completely dry the coin Selector. CLEANING THE COIN SELECTOR (SR3) 1 2 3 4 GATE RUNWAY ...

This test is used to check all configured outputs from the IO board. Use the SERVICE button to move the cursor to the desired test item. Press the TEST button to test the selected item. PEASHOOTER RED Change the colour of the Peashooter to RED PEASHOOTER GREEN Change the colour of the Peashooter to GREEN PEASHOOTER BLUE Change the colour of the Peashooter to BLUE PEASHOOTER SOLENOID Test the solenoid inside of the Peashooter PANEL RED LED Change optional lighting to RED PANEL GREEN LED ...

3 In order to avoid accidents, check the following before starting the operation: • To ensure maximum safety for the players and the customers, ensure that where the product is operated has lighting to allow any warnings to be read Operation under lighting can cause bodily contact with each other, hitting accident, and/or trouble between customers. • Be sureto perform appropriate adjustment of the display (LCD, Plasma, CRT or Projector). For operation of this machine, do not leave monitor's or deviation as is. Failure to observe this can have a ...

COIN COUNT Coin Count value from IO board (cannot reset) CREDITS Total number of Coin credits added to the system SERVICE CREDITS Total number of Service Credits added to the system FREEPLAY ON – Freeplay is on, pressing the Peashooter trigger during attract sequence will issue a credit. OFF – Credits can only be added using coins or service button. EXIT This will save any changes to Freeplay to this cabinet only ...

4 Carefully slide out the Controller Base and Control Panel in opposite directions as illustrated. 5 Remove the 4x M8 Hex Bolts located at the base of the Controller. Take care in disconnecting the Controller Harness and remove the controler. REMOVE FIXINGS REMOVE FIXINGS ...