Dual 12V Owner's Manual

CD Operation Installation Before You Start • Consult a qualified technician for instructions. Dual always recommends professional installation. • Disconnect negative battery terminal. • Remove trim ring from unit (if installed). • Remove 2 transit screws located on top of the unit (if applicable). • Insert the removal keys, and remove the mounting sleeve from the head unit. Note: Most vehicles require an installation kit, wiring harness and/or antenna adapter (all sold separately) to properly install the head unit in the vehicle. Installation Process 1. Carefully remove the existing head unit. 2. Connect wiring harness. Consult a qualified technician if you are unsure. 3. Mount the head unit using the mounting sleeve or ISO brackets (depending on your vehicle’s dashboard). 4. Connect wiring harness and antenna. Test the head unit for correct operation. 5. Slide into mounting sleeve to secure, or mount the ISO brackets to the vehicle. 6. Snap trim ring into place. Wiring Connections The chart below defines the connection for each wire in the wiring harness. Color Connection Red 12V Ignition / Accessory Yellow 12V Battery / Memory Black Ground Blue Power Antenna / Amp Turn-on Grey Right Front (+) Grey/Black Right Front (-) White Left Front (+) White/Black Left Front (-) Purple Right Rear (+) Purple/Black Right Rear (-) Green Left Rear (+) Green/Black Left Rear (-) Step 1: Insert the mounting sleeve into the installation kit or dashboard. Step 2: Bend multiple mounting tabs around the mounting sleeve until the mounting sleeve is secure. Step 3: Connect all wiring harnesses and slide the head unit into the mounting sleeve until it clicks into place. Using the existing brackets or the brackets supplied with the installation kit, mount the brackets to the sides of the head unit with the screws supplied with the head unit. To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. Power On/Off Faceplate Removal Changing Modes Volume Mute Auxiliary Inputs Reset Setting the Clock Display Menu Press the button to turn the unit on. Press again to turn unit off. Press the OPEN button and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Press SOURCE to enter the source menu. Turn the volume knob to cycle to the desired source, and press SELECT to confirm. Adjust volume using volume knob. Press to silence the audio. Press again to resume listening at the previously selected volume. Insert a 3.5mm cable in the front AUX port or RCA cables into the rear AUX-IN connectors. Press the RESET button to reset the unit back to the factory settings if abnormal operation occurs. The reset button is located behind the front panel. With the unit on, press MENU until the General menu appears. Highlight the clock and press SELECT. Use the volume knob and SELECT buttons to adjust the time. Press DISP to toggle display between various displayed information. Press MENU to access the audio and setup menu options. Seek Tuning Manual Tuning Band Storing Presets Recalling Presets Insert CD Eject CD Track Select Fast Forward/ Reverse Pause Intro Repeat Random CD-R/CD-RW Compatibility Press TUNE nn or TUNE ll for more than one second to seek to the next strong station. Press TUNE nn or TUNE ll momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. Press BAND to select between FM1, FM2, FM3, AM1 and AM2 bands. Up to six presets can be programmed for each band, enabling up to 18 FM stations and 12 AM stations to be stored in memory. Select the desired band and station. Press the (F)unction button, turn the volume knob until the desired preset number is highlighted, then press SELECT to store the preset. Press the P+ or P- buttons to cycle through the 1-6 presets in the current band. Press the OPEN button to open the front panel. With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT (located behind the front panel) to eject the CD. The unit will change to previous mode of operation. Press TUNE ll to skip to the beginning of the next track. Press TUNE nn to return to the beginning of the current track. Pressing TUNE nn again skips to the beginning of the previous track. Press and hold TUNE ll or TUNE nn to fast forward or reverse a track. Press l/ II to temporarily stop CD playback. Press l/ II again to resume playback. Press (F)unction to access the Intro menu. Intro will play the first 10 seconds of each track. Press (F)unction to access the Repeat menu. Repeat will continuously repeat the selected track. Press (F)unction to access the Random menu. Random will play all the tracks in random/ shuffled order. Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media type and recording method. Refer to the online owner’s manual for details. Mounting the Head Unit: ISO mounting Mounting the Head Unit: Typical DIN mounting Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp. agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new, renewed or comparable product (whichever is deemed necessary) in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. Subsequent replacement products are warranted for the balance of the original warranty period. Who is covered? This warranty is extended to the original retail purchaser for products purchased from an authorized Dual dealer and used in the U.S.A. What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered: software, installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product. Specific license conditions and copyright notices for the software can be found via www. dualav.com. What to do? 1. Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls may save you a service call. 2. If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center. 3. Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment. 4. For more information and for the location of the nearest authorized service center please contact us by one of the following methods: • Call us toll-free at 1-866-382-5476 • E-mail us at [email protected] Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages. FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2013 Dual Electronics Corp. All rights reserved. NSA0313-V01 Operation of iPod/iPhone Operation of iPod/iPhone Connect an iPod/ iPhone Device (sold separately) Device Compatibility Song Select Fast Forward and Reverse Pause Repeat Random Intro To play music from an iPod/iPhone device, connect the USB cable (included with your iPod/iPhone device) to the unit’s USB port. Playback will begin automatically. Refer to the online Owner’s Manual for a complete list of compatible iPod/iPhone devices. Press ll to skip to the next song. Press nn to return to the beginning of the current song. Pressing nn again skips to the beginning of the previous song. Press and hold ll or nn to fast forward or reverse a song. Press l/ II to temporarily stop playback. Press l/ II again to resume playback. Press (F)unction to enter the Repeat menu, then turn the volume knob to select one of the following options: • Off - Repeats all tracks. • Current Song - Repeats selected track. Press (F)unction to enter the Random menu, then turn the volume knob to select one of the following options: • Off - Cancels the RDM function. • All Songs - Plays all tracks in random order. • Current Album - Plays all tracks in the selected album in random order. Press (F)unction to enter the Intro menu, then turn the volume knob to select one of the following options: • Off - Cancels the INT function. • On - Plays first 10 seconds of each track. Music Search Manual Control for iPod Press SELECT, and the main search menu will appear. Select a Category: Turn the volume knob to select between artists, albums, songs, playlists, podcasts and audiobooks. Press SELECT to select the desired search category and/or subcategory. Step Backwards: Press BACK to return to the previous menu or to exit the search menu when the main menu is shown. Playing a Song: Navigate to the desired song/ podcast/audiobook, and press SELECT to begin playback. When “MANUAL” control is selected from the Setup Menu, the iPod or iPhone device can be controlled directly from the device’s interface. All functions except for volume can be used from the iPod or iPhone device. Note: The firmware of the iPod/iPhone must be updated to the latest version to be compatible with manual control mode. Note: Not all iPod/iPhone devices are compatible with manual control mode. Pandora® Operation To download the complete Owner’s Manual for your radio, please visit www.dualav.com/support/manuals.php. Mounting Sleeve Dashboard or Installation Kit Mounting Sleeve Dashboard or Installation Kit Mounting Tabs New Radio Existing Brackets Decorative Bezel Mounting Sleeve Dashboard or Installation Kit Head Unit MP3 / WMA Operation Playing MP3/WMA Files Track Select Fast Forward and Reverse Pause Folder Access Repeat Random Intro To play MP3/WMA files, insert a data CD or USB device containing MP3/WMA files. Press TUNE ll to skip to the beginning of the next song. Press TUNE nn to return to the beginning of the current song. Pressing TUNE nn again skips to the beginning of the previous song. Press and hold TUNE ll or TUNE nn to fast forward or reverse a track. Press l/ II to temporarily stop playback. Press l/ II again to resume playback. Press P+ to select the next folder. Press P- to select the previous folder. Folder access is only available on discs or devices with more than one folder. Press (F)unction to enter the Repeat menu, then turn the volume knob to select one of the following options: • Current Song - Continuously repeats selected track. • Current Folder - Continuously repeats all files in folder. Press (F)unction to enter the Random menu, then turn the volume knob to select one of the following options: • Off - Cancels RDM function. • All Songs - Plays all tracks in random order. • Current Folder - Plays all tracks in folder in random order. Press (F)unction to enter the Intro menu, then turn the volume knob to select one of the following options: • Off - Cancels the INT function. • All Songs - Plays first 10 seconds of each track. • Current Folder - Plays first 10 seconds of each track in the selected folder. Requirements USB Connection Changing Stations Shuffle Skipping Tracks Play/Pause Thumbs Up Thumbs Down Device Compatibility Troubleshooting Control for Pandora requires: • An iPhone device with a reliable data connection, or an iPod touch that is connected to wireless internet. • The Pandora App installed on the iPhone/iPod device. • An active account with Pandora. Sign up at www. pandora.com. • The USB sync cable that came with your iPod/iPhone device. Connect an iPod touch or iPhone device (required, sold separtely) to the USB port, using the USB sync cable included with your iPhone device. Press SELECT to display the stations menu. Turn the volume knob to cycle through the list of stations, then press SELECT when the desired station is highlighted. Note: Stations must be created on your account prior to connecting your iPod/iPhone device to the head unit. Press SELECT to display the stations menu. Choose “Quick Mix” from the stations menu to shuffle songs from all of your stations. Press ll to skip the current song. Press l/ II to temporarily stop playback. Press l/ II again to resume playback. Press to tell Pandora you like the current track. Pandora will play more tracks with similar qualities. Press to tell Pandora you do not like the current track. Pandora will not play the current track again, and will avoid playing tracks with similar qualities. Refer to the Owner’s Manual for a complete list of devices compatible with this head unit. Refer to www.pandora.com/everywhere/mobile for devices compatible with the Pandora mobile application. Note: Pandora is an internet service, carrier and data charges may apply. Fuse: When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. Tip: When a suitable ground wire is not present in the vehicle wiring harness, connect the black ground wire to the vehicle chassis. Car Audio Quick Start Guide This Quick Start Guide provides basic instructions for using your Dual Receiver. To download the complete Owner’s Manual please visit www.dualav.com/support/manuals.php and type in the product’s model number or call customer service at 1-866-382-5476. t h i n k b e f o r e y o u p r i n t