MTW Belarus 90 Operating Manual

47 Internal ties (2) They are also used for limiting side sway of machines both in transport and operational positions. NOTE: Telescopic ties are mounted only from the outside. Partial interlock (for tillage) Observe the following order of adjustment with a machine in operational position: • Screw adjusting bolts (1) into brackets to the full; • Lift the machine so that its tools couldn’t touch the ground; • Adjust the length of the right-hand brace to the requi ...

44 Mounting machinery on tractor 1. Before mounting machine on the tractor, first make sure there are no people in the machine mounting zone. 2. Using draft control lever (if installed), lower the hitch attachment into down position, pull tractor back and hinge the machine to lift links. Fasten the pins by cotters. Shut down the engine. 3. Extend or shorten the top link (1) and couple the hitch ball to the machine. Fasten the pin by cotter. 4. If necessary, set the top ...

Belarus – 90/92 Operating manual 109 Section H. POSSIBLE MALFUNCTIONS AND REMEDIES MALFUNCTION, SYMPTOM REMEDY ENGINE Engine doesn’t start Air in the fuel system Bleed the system using manual fuel priming pump. If necessary, remove air inflow. Take off fuel pump from diesel and send it to repairs. Engine doesn’t develop power There is no full fuel feeding because of disarrangement of tie-rod of control fuel pump. Filtering element of fuel fine filter is clo ...

39 The beginning of tractor movement ATTENTION! When selecting required movement speed use the gear shifting diagram. To put tractor in motion do the following: • Press clutch pedal to the full; • Shift lever (2) to the extreme left position and pull or push it to select I or II mode, correspondingly; • Turn lever back to “neutral” position and then further to the right, select the required gear and pull or push the lever (2) to set selected speed. • Push or ...

Belarus – 90/92 Operating manual 82 'Operation 13. Checking plays of steering joints After each 250 hours of operation check steering joints by hand force shaking or wheel turning. To regulate steering joints, please do the following: а) Take off locking wire (2) from the lug 3. b) Screw up threaded plug (1) in a way to eliminate clearance in joint connection. c) Lock the plug with wire. NOTE: If backlash can not be eliminated by screwing up threaded plugs, disassembly the joint and replace worn out parts. 'Operation 13а. Checki ...

Belarus – 90/92 Operating manual 100 Operating 41. Engine oil pre-filter  Loosen four clamps of connecting sleeves and remove filter from oil conduit, under engine oil radiator. IMPOTANT! Make notice of how filter was placed in oil conduit. Random filter installation is not allowed. Wash filter in diesel fuel and blow off with compressed air in the direction of arrow imprinted on the filter housing. Mount the filter, paying attention to its correct orientation in the oil conduit. Tighten clamps of sleeves. Operation 42. Washing ...

Belarus – 90/92 Operating manual 76 Daily maintenance (DM) after every 10 hours of operation or daily Operation 1. Oil level in engine casing Shut down the engine, wait for 15 minutes and check oil level. Oil level should be between lower and upper probe (3) marks. If necessary, remove cover (2) of oil filling neck (1) and fill oil up to the top mark of probe (3). IMPORTANT! Do not operate engine with oil level below lower mark of oil gauge. IMPORTANT! Do not fill oil above the level of oil gauge upper mark. Surplus oil will burn, ...