MTHTrains Sunny Pool Series User Manual Manual

9 Note: the inner cover is produced to be under- sized, i.e. it is slightly smaller than the sheet casing. This is the only way to avoid possible folds in the foil, but they cannot be prevented completely. However, this does not constitute any quality impairment and has no effect on the service life of the foil. Because the foil is under- sized, the piping has to be stretched when fit- ting the foil; more when the weather is cold, and less when it is warm. A) Fitting the inner cover foil with conventional piping. Evenly lift the wall section of the pool inner cover (5) and fit it ...

The place chosen for installation of the swim- ming pool must be completely flat, so that any little slopes must be evened out accordingly. The ground under the swimming pool should be so- called natural ground. It must not consist of heaped up ground. Any heaped up ground must be compacted in such a way that it can take the necessary swimming pool load of 1200 kp/m2 for a pool depth of 1.20 m or 1500 kp/m2 for a depth of 1.50 m. The ground excavated for the swimming pool must be approx. 1 m larger in diameter than the pool itself. Before you begin with the actual install ...

If the swimming pool is to be emp- tied and cleaned, it should be refilled again preferably on the same day. Otherwise there is a risk particularly during bad weather (rain) of the backfilling shifting and deforming the steel casing. When using a pump to empty the swimming pool, make sure that the water is drained at a good distance and certainly not allow- ed to seep into the ground in the immediate vicinity of the swim- ming pool. 4.2 Repairs Damage to the pool inner cover can be dealt with easily using a repair kit. Please comply with the ...

Press the first segment onto the edge of the swimming pool over the fitting profile or special profile. Then fit the second segment of handrail exactly onto the first segment using the connec- tion tube. Continue until the entire handrail has been completed. Adjust the precise length using the provided partial piece of handrail or by sawing the handrail with a hacksaw. Once all handrail segments have been fitted on the edge of the swimming pool, knock the indi- vidual handrail pieces onto the swimming pool wall using your hand or a rubber mallet. If gaps have appeared ...

The place chosen for installation of the swim- ming pool must be completely flat, so that any little slopes must be evened out accordingly. The ground under the swimming pool should be so- called natural ground. It must not consist of heaped up ground. Any heaped up ground must be compacted in such a way that it can take the necessary swimming pool load of 1200 kp/m2 for a pool depth of 1.20 m or 1500 kp/m2 for a depth of 1.50 m. The ground excavated for the swimming pool must be approx. 1 m larger in diameter than the pool itself. Before you begin with the actual install ...

Please do not let children play at or in the pool without supervision. Explain to them about the dan- gers (keep the swimming pool covered for example with a safety cover if it is not under supervision). Always have a shower before get- ting into the pool. People suffering from circulatory disorders should get into the pool slowly. Caution: danger when falling in. Low water depth. Do not jump into the pool. Caution: make sure that only a qualified electrician connects up any electrical appliances such as filter systems, underwater spot- lights, etc. according to ...