Morso 1410 Instructions For Installation And Use Manual

Beskrivelse Produktnr. Svær rysterist 44203300 Rysterist 44203000 Risteramme 44203100 Røgledeplade 44141100 Forrist 44141400 Glas 1410 790726 Glassæt 1410 62904000 Glas 1440/1450 790724 Glassæt 1440/1450 62904100 Sidesten 790935 Bagsten 790934 ...

A wall sleeve should be bricked securely into the wall of the chimney at the appropriate height and the stovepipe inserted centrally. The pipe must not extend into the actual chimney open- ing, but rather must reach only to the inside of the chimney aperture. The gap between the stovepipe and sleeve must be sealed using glass fibre packing rope. Only use stovepipe components that comply to National and Local Building Regulations. 1.8 Connecting to a stainless steel insulated chimney system If your installation involves taking the chimney straigh ...

E-Mail: [email protected] · Website: www.morsoe.com Instructions for installation and use 1410, 1440 & 1450 EN 13240 ...

The stove heat emission is regulated using three air controls. Primary air supply where air passes through the riddling grate is operated using the two lower air controls, and secondary air which is added to the combustion over the glass is operated using the upper air control. A third air inlet provides a constant, pre-heated air supply which is added to the combustion just above the fire. This air supply cannot be regulated. The stove’s rated heat output is 7.8 kW. Your new Morsø stove is EN-tested for firing with wood, and is suitable for intermittent use. N ...

DK 1.0 Opstilling af Deres Morsø ovn. .. .. .. .. .. .. .. .. .. .. .. ..5 2.0 Fyringsteknik/Brugen af Deres ovn . .. .. .. .. .. .. .. 10 3.0 Regelmæssig vedligeholdelse af ovnen. .. .. .. .. .. 14 4.0 Alternative brændselsformer. .. .. .. .. .. .. .. .. .. .. .. 16 UK 1.0 Installing your Morsø stove .. .. .. .. .. .. .. .. .. .. .. .. .. .. . 2.0 Firing/using the stove .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. . 3.0 Routine stove maintenance.. .. .. .. .. .. .. .. .. .. .. .. .. .. . ...

A lot of air is needed when first lighting the stove. When starting with a totally cold stove, it may be helpful to leave the door ajar (2-3 cm) during the first few minutes; the secondary air intake should be fully open. You should build and maintain the ash bed to a thickness of approximately 1 cm. 1. A layer of embers will form rapidly if the stove is lit with 2 - 4 fire lighters or 7 - 10 rolled up sheets of newspaper, underneath roughly 1 kg of dry kindling. 2. Fully open the top vent so that the secondary air supply can enter the firebox. 3. After ...