Mitsubishi Electric MR-JET- G Series Operation & User’s Manual

1.3 Handling methods for alarms/warnings 47 1 [AL. 046.7_Abnormal temperature of servo motor 5] Cause Check/action method Model 1. The values of the servo parameters for manufacturer setting were changed. Restore the values of the servo parameters for manufacturer setting to the initial values. [JET-G] ...

1.2 List of alarm No./warning No. 13 1 0E6 0E6.1 Warning SD     0E8 0E8.1 Warning      0E8.2 Warning      0E9 0E9.1 Warning DB     0E9.2 Warning DB     0E9.3 Warning DB     0EC 0EC.1 Warning      0ED 0ED.1 Warning      0F0 0F0.1 Warning      0F0.3 Warning      0F2 0F2.1 Warning      0F2.2 Warning      0F2.3 Warning      0F2.4 Warning      0F2.5 Warning    ...

1.3 Handling methods for alarms/warnings 57 1 [AL. 069.4_Reverse rotation stroke end detection - Command excess error] [AL. 069.5_Upper stroke limit detection - Command excess error] [AL. 069.6_Lower stroke limit detection - Command excess error] Cause Check/action method Model 1. The command position exceeded 30 bits from the position which was detected after detecting LSN (Reverse rotation stroke end). Review the operation pattern so that the command does not exceed 30 bits. [JET-G] 2. The reverse rotation stroke limit switch is not connected to LSN (Rever ...

1.3 Handling methods for alarms/warnings [AL. 0E3_Absolute position counter warning] • The multi-revolution counter of the absolute position encoder exceeded the maximum range. • There is an error in the absolute position encoder pulses. [AL. 0E3.1_Multi-revolution counter travel distance excess warning] [AL. 0E3.2_Absolute position counter warning] [AL. 0E3.5_Encoder absolute position counter warning] Page 78 [AL. 0E3.2_Absolute position counter warning] Cause Check/action method Model 1. In the absolute position system, the travel distance from ...