quadient IS-420 Quick Installation Manual

2 Base, 3 Catch tray. CONNECT THE LAN to a network RJ45 plug of the Base and to the LAN wall socket using the LAN cable B . If included in your system, CONNECT THE SCALE (see its Quick Install Guide). OPEN THE BASE COVER, remove the headset protecting strips and insert the headset in its compartment, then push the headset back until it clicks. WRITE DOWN THE PSD number, you may need the number later. INSTALL THE PSD in one of the slots then close the cover. CONNECT THE SYSTEM POWERPLUG. Follow the installation wizard on the screen. Refer to the installation section in the User Guide. IS-420 QUICK INSTALLATION GUIDE CAUTION: use a solid and steady table, far from any door or fan. 7 4 8 5 3 6 2 3 1 C B C A 1 Check the box contents. 2 For more information about your mailing system, please visit: kb.quadient.co.uk/is420_ug

mailing system, see the User Guide. Press Clear or Wake To reset previous settings... Choose rate and services When the weight is displayed... Consumables, contact Quadient Supplies: 0845 880 0002 For your installation Pin Code please visit www.quadient.co.uk Put your mail on the scale To weigh your mail... or Enter the weight manually Shortcut keys Getting to know your mailing system Applying postage Changing the ink cartridge Screen main areas 1 2 1 2 If needed, press to get back to the home screen. To get back to default rate settings, press on the keyboard. If the system is asleep, press to wake it up with default settings. 1 2 3 Current rate and select- ed services are displayed in this zone of the screen. Rate and services (to change: K1) Date printed (to change: K4) Weighing type (to change: K6) Imprint position offset Postage and weight Job memory (can contain rate, stamp settings and account) Current account D1 D2 D3 D4 D5 D6 D7 K1 K2 K3 K4 K5 K6 K7 K8 K9 Rates and services selection Memorized jobs (rate, stamp settings, account) Credit management Type of imprint and Imprint settings Label printing Weighing modes Sleep / wake (amber / green) Stops printing Starts printing Check that the D3 icon is . Otherwise, press and then select the option Standard weighing. Press and then select the option Manual weight entry. Enter the weight and press OK. Press OK to validate your selection and return to the home screen. Use the keypad to select an available Class and/or Services, or select key 8 for the wizard. To change the rate and/or add services: Press . The rate selection screen is displayed. 1 2 On the new ink cartridge, remove the protective strips from the printing heads. Raise base cover and follow instructions printed on sticker inside. Print the stamp To print on labels When the postage is displayed... 1 2 If you want to print on a label, see the alterna- tive sequence below. Press to start the motors of your mail- ing system. Insert the mail piece in the mail path, the imprint printing position on the upper right side. Insert labels into the dispenser until a click, printing side facing the right. Press to enter the number of labels to print and then press . 1 2 If jamming occurs... Adding credit Press , type 2 and follow the instructions onscreen. Note: to complete this operation successfully, your postal services account must have a positive credit balance of the corresponding amount. Press on the control panel to stop the motor. Under the base, lift up the release handle and, using your other hand, remove stuck envelope or labels. 1 2 K7 K8 K9 K4 K1 K2 K5 K6 K3 A0021368/C - 31/03/2020 D5 D6 D7 D4 D3 D2 D1 IS-420