METHVEN 01-8444 Installation Manual

ABN 15 104 813 390 Melbourne, Australia www.methven.com WMKA21005 IMPORTANT Please read all of the instructions before installation MA018444 Waipori Wall Top Assembly 01-8444 (Pair) Use of this product is recommended for domestic and commercial applications. Domestic and commercial warranty terms and conditions vary. Please refer to the Methven website for full warranty terms and conditions - www.methven.com All pipework must be thoroughly flushed prior to the installation of the mixer. Inline filter washers must be installed on both hot and cold supplies to prevent foreign particles damaging the ceramic head works. Do not remove the ceramic head works from the mixer when installing. Damage caused by hydrostatic testing is not covered by Methven’s warranty. Methven recommends a licensed plumber carry out all installations in compliance with the requirements of AS/NZS 3500. This product complies with AS/NZS 3718 regulations. JANUARY 2012 Installation Guide www.methven.com Customer Care Hotline: 1300 METHVEN (638 483) Email: [email protected] Note: It is the responsibility of the installer to ensure a water proof seal is achieved between the faceplate and the finished surface of the wall. If in any doubt about the quality of the seal, the faceplate should be removed and then reinstalled using silicone to ensure a seal is achieved. Installation Ø 35mm Ø 35mm Distance from mounting stud to front of wall lining: Std - 54-64mm Ext - 64-76mm Hot Cold Do not discard screws For deeper installations, remove short threaded headworks collars, replace with long threaded headworks collars and spindle extensions. 1. 2. 3a 4. 3b. 5.

with the table below No. Item description Qty supplied 1 Headworks 2 2 Base ring 2 3 Grub screws 2 4 O-ring 2 5 Locking nut 2 6 Cold handle 2 7 Hot handle 2 THE METHVEN GUARANTEE The warranty statement shall apply to all tapware & showers supplied by Methven For more information visit www.methven.com THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia Technical Specification Inlet Connections: All 1/2" BSP Operating Pressure: 150kPa - 500kPa For optimum performance hot and cold water pressures should be equal. AS/NZS 3500 stipulates a 500kPa maximum operating pressure at any outlet within a building. Where normal pressure exceeds 500kPa, a pressure limiting valve must be installed. Operating Temperature: Recommended hot water supply 50°C, maximum 70°C. AS/NZS 3500 requires all hot water supplies to any sanitary fitting to be tempered to 50°C. Ceramic cartridges: Warranty claims will be void where the ceramic head works has malfunctioned due to the presence of the following within the water supply: Copper tube pieces Plastic pieces Sand, dirt or stones Thread tape Other objects not normally present in the potable water supplies www.methven.com Customer Care Hotline: 1300 METHVEN (638 483) Email: [email protected] 04-9905 Hot 04-9752 Standard Spindle & Handle Assembly Set Up Spindle Handle Extension 04-9837 Spindle Flange M x F Extension 04-9875 SPARE PARTS (NOT INCLUDED) (NOT INCLUDED) (NOT INCLUDED) Cold 0 69 Handle Parts / Assembly Care and Cleaning Never use abrasives to clean this product. Clean regularly with contamination free warm soapy water and a damp soft cloth. Damage caused by using unsuitable cleaning agents is not covered by warranty. Grub screws Locking nut Cold handle