KVM-TEC Masterline MVX Manual 

picture) USB is not working No Power (No LED) Check the powerplug Is the power supply ok? Try another Unit. Try reprogramming the Unit by using a JTAG programmer Contact kvm-tec support Are the USB Devices plugged in correctly? Is the USB cable on the Local side plugged into the PC? Are the USB Devices working directly on the PC? Check if local and remote Unit have the same fi rmware Replace the USB cable from PC to the Local Extender Check if the local or the remote Unit is causing the problem by swaping fi rst the local and than the remote Unit to another Unit Contact kvm-tec support Check if all cables are plug- ged in correctly Check if the PC is sending a Image by plugging in a monitor on the local out of the local Unit Check if the DDC is set correctly (in menu under point „O“) Check if both Units have the correct fi rmware No Video Contact kvm-tec support Check if all cables are plug- ged in correctly Check if the PC is sending a Image by plugging in a monitor on the local out of the local Unit Check if local and re- mote Unit have the correct fi rmware Check if the DDC is set correctly (in the menu under point „o“) Check if the network switch is setup correctly and has enough bandwidth Contact kvm-tec support Check if other units have the same behaviour We are here for you to answer your questions about installation? Manual download www.kvm-tec.com or kvm-tec Installationchannel on our homepage personally +43 2253 81912 kvm-tec Support [email protected] Phone: +43 2253 81912 - 30 Check out our Installation Channel: www.kvm-tec.com line line master kvm-tec QUICK Instruction Masterline MVX 6701 SET 6701L CPU/LOCAL 6701R CON/REMOTE connect collaborate communicate control kvm-tec = C 4

DVI out to Monitor Audio from PC Audio to PC USB from Keyboard and mouse Audio from Microphone Audio to Speaker Network cable CAT5e/6/7 up to 150m/492ft Quick Installation MVX1 Masterline local / CPU – remote/ CON 1. Connect the CON / Remote and the CPU / Local Unit to the included 12V 1A power supply. 2. Now connect the USB cable to a USB port on your PC and connect the other end of the USB cable to the CPU / Local Unit. Connect keyboard and mouse to the CON / Remote Unit. 3. Connect the CPU / Local and the CON / Remote Unit with a network cable. 4. Now connect the DVI cable to the DVI socket of the PC and the other end to the DVI socket of the CPU / Local Unit (DVI-in). Then connect the monitor to the CON / Remote Unit with a DVI cable. 5. Then connect PC audio out with the audio cable to Local Audio in. Then connect audio / out via the audio cable 6. Almost done! Now connect the audio cable Local Audio / out to the PC Audio in and Remote Audio / out with the audio cable to the microphone. HAVE FUN - your kvm-tec Extender is now in use for many years ( MTBF approx 10 years) Power plug 12V 1A DVI out to Monitor