Tyredog TD-2300A Programming Replacement Monitor

Before you start. Make sure the relay has power and the relay top cover is removed (If top cover is fitted remove 2 screws to remove cover) so you can access the programming button. Step 1: Adding a New Monitor to a Relay and Saving the layout. Press and hold the Mute (Left) button down for a few seconds until the Unit settings menu appears. Press the Mute (Left) button a couple of times to scroll across to menu C (Type of vehicle), Press the Backlight (Right) button to enter this menu. TYPE of TRUCK HEAD and your current Layout No. will be displayed. Use the Mute (Left) or Temperature (Middle) button to scroll through the vehicle layouts until you find your new layout then press the Backlight (Right Button) or to keep the existing layout just press the Backlight (Right Button). Make sure TYPE of TRAILER is set to NO.1 NONE by using the Mute (Left) or Temperature (Middle) button to scroll through the vehicle layouts then press the Backlight (Right Button). Note: If you do have Trailer Relays, then you would need to select your Trailer Layout for each Trailer. Make sure Receive from Relay is highlighted Black like shown then press the Backlight (Right Button) and this will take you back to the settings menu. Applicable to TD-2700F Models only. Press the Mute (Left) button to scroll across to menu D (Add new Relay). 15 1 NONE TYPE of TRAILER 1 Receive From Sensor Relay

menu. PUSH BUTTON ON RELAY TRUCK HEAD your current Layout No. will be displayed. Now Press the reset button on the relay once (short press only). This will program the relay to the system. The Monitor will beep and will briefly show an ID for the relay for a couple of seconds. Note: If you have Trailer Relays, press the Left Mute button to program the Trailer Relay also. Now press the Backlight (Right Button) and this will take you back to the settings menu. The Monitor and Relay(s) are now programmed. Now either switch the monitor OFF and ON using the switch on the side of the monitor. Or Press the Backlight (Right) button then the Temperature (Middle) button to exit the menu on the monitor. Test all sensors are working and programmed and set the Alarm Warning Thresholds if required. ID: 0012A6